Viewing all customer Discussions for:

26-393B Tilt Latch Pair

I have been unable to find the correct size that I need I went to Lowe's and HD. They only have ones that are larger. they do not fit. I have enclosed photo's thank you.

I think this is a tilt latch for a silverline window. Do you carry this part?

1.Top window track clips 2.Also the "shoe" for these type of balances (Track roughly 1"in wide 3/8" thick) Thx for the help

Please get back to me with the part numbers for the items that are photoed below.David

I have two windows that were closed for an extended period of time. When I opened and then closed them the grey items in the photo broke. As you may be able to see, the tops broke off which were, apparently, what held them inside the bar in the track (see photo). These windows are a little over ten ... (cont.)

Need a replacement tilt window latch

Both left and right side have broken out of window. Can you help identify which part is needed?Measurements are as follows... 2 3/8 long x 11/16 wide. The sliding angled lock is 3/8 wide.End view...sliding angled lock width is 3/8. height is 3/8.Overall width is 7/16.

What is this part and can I still get them?

My apologies, this is the third email I sent you guys. Disregard the other two. I took the time to gather the info and I think I know what I need. Just need confirmation. LatchesMy latches are 2 3/8 x 11/16 and are the ones pictured. I believe the replacement would be 26-393B for the pairShoesI disa ... (cont.)

i need new tilt locks for several windows - couldn't find any part numbers or names on the window to id the maker.

These are for American Craftsman tilt windows. The company no longer carries this size. It measures 2 and 3/8 long and 5/8 wide approximately.

I need a new tilt latch and channel balance. I'll send a new picture of the tilt latch and was told by a representative that i'll need to weigh the bottom sash since there's no stamp on my balance.

Hi, This plastic piece has broken on the Stanley window and I need the replacement part. Thanks!

I am sending an attachment which I hope will help you find my tilt latch. I know it's not the 26-390, 26-391. The dimensions of the unit are length 2 3/8", width 11/16", tooth width 7/16 ". It is inserted in the groove in the window.

No markings on Windows double hung top window

Series 2900 Dual Glazed Vinyl Single Hung Low E Glass Grids Windows

2 3/8" left and right. I have only been able to find 2 5/8" which are too big.

The tilt mechanism is 2-3/8 x 11/16. The latch is approx 2-7/8 by 1 inch. There are no numbers anywhere! The windows are ivory in color.

the tilt latch measures 7/16" deep 11/16" wide and 2-3/8" long the pivot measures 9/16" thick 2-1/16" long by 1-1/4" wide Please advise on part numbers I need. Also one picture shows that there are no sash stops at top to hide the necessary notch. What can I use to cover this. Thank You, Louis ... (cont.)

Wp-97853