Viewing all customer Discussions for:

32-059 17-5/8" Self-Closing Drawer Slide Pair

I've been to several hardware stores trying to find a drawer glide that will work with drawers in my kitchen that have had the glides break. I need a glide to mount at the back of the opening which will support the track that holds the drawer. I've attached some pictures to give you an idea of wha ... (cont.)

when you say this drawer slide is 17-5/8" 32-059 where are you measuring from? My drawer is 16" from the back side of the face or stile to the rear most part of the box. will these slides work or do I need the shorter version?

2 1/2 in. Long 1 3/4 in wide (kitchen). No Model #

I have ordered several replacements and not have been the correct size. The issues I've had is they are too narrow for the slide to get into the bracket. There is no markings or any identification on the part. If you could help I would appreciate it.

This opening for the slide to fit in is 1.25" All of the new ones I find at hardware stores are 1" or 7/8". Can I find this size anymore? Cabinets are about 20 yrs old

This is a plastic drawer slide guide that goes in the back of the cabinet. The metal slide goes in the plastic piece. I do not have the name of the company that installed the cabinets nor do I have the name of the cabinet as these were installed when the house was built. Kindly let me know if you pr ... (cont.)

The top set is from a pull-out drawer in kitchen. The bottom set is from a drawer in our den. No part numbers are displayed on the parts. These are both from cabinets installed in 1991. Can you help me to determine as to which replacement parts I need for the sockets and glides if necessary. ... (cont.)

I'm in the process of renovating master bathroom vanity. The original UNIGRASS6000 drawer slides are 32 years old and work fine. I'm interested if I can replace these with self closing type without major changes to existing cabinet/drawer setup. Thanks, Mark

My drawer left slide(facing my drawer) got bend I need an replacement part with screws .. bend slide has Unigrass 6600 mark on side and 5 G on the other side.

The drawer guide attached to the drawer, the Plastic roller wheel broke off. Need to replace two.

Need to know if I?m ordering the right part?

Hello, I have a need for at least 6 each of the rollers shown in the attached file. This roller is less than .5 "

Hi. I'm looking for a replacement part for an 18" grant sliderite. Thanks, Jules

my slide is 17 3/4" long by 5/8" high and has two 1/2" wheels riveted on. One of the wheels broke off. Can you get me a new slide, if not replacement wheels.

TWIMC, The little wheels/rollers came off the side of a dresser drawer. The drawer itself has heavy duty metal sides (6" x 14-1/2") and the drawer front, back and bottom are wood/MDF. There are plastic brackets attached to both sides at the top back, where the metal sides meet the wood back. Thes ... (cont.)

I have a bathroom vanity with a drawer assembly that has a pair of 1/2" (Outside diameter) wheels that fit into a metal track. The wheels (one on each side of the bottom of the drawer -- in the very back) are attached to back of the drawer with two staples. I would very much like to locate a pair of ... (cont.)

I need a few replacement nylon rollers for my drawer slides. The rollers I need are 7/8 inch, with 1/2 inch holes. The first picture is of the drawer slide without the wheel. The second picture is of a complete drawer slide. The third picture is of the broken wheel. I would appreciate any hel ... (cont.)