Viewing all customer Discussions for:

38-036 Rear Mount Casement Lock, 2-1/2"

I tried Swisco's 38-036 reverse mount casement lock but it doesn't fit. It's to big to fit into the space. Any ideas?

Hello I hope you can assist I have to replace three broken PGT window casement locks. See attached. Do you sell? How do I screw them off and insert new ones Help please

Searching for 2 30270 Looking for casement window locks the crank is a truth so I would believe the lock is also

These are certain-teed windows.

looking for replacment parts for windows.Thank YouDan C.

2 1/2 in back screw centers 3in handle Bronze

Do you have this part? Thank you, PAD

Need 6 of attached part. Thank you

Looking for a window crank assembly. U.S. patent number 4,241,541 It reads "Truth" as the brand. This one the short arm reads #30842R and after the joint, there is a second arm attached with # 20810 stamped in it. The larger arm is 9" from the gear to the center of the roller.The base has 7 holes an ... (cont.)

Hi, We have a customer looking for this specific window part with the base as well.

The mounting screws are 2-1/2" apart, the inside gap between the latch and the backside of the body is 3/4". the overall body (not the handle) is 3". The widow is equipped with four (4) latches.

Do you carry this window latch for my widow that cranks open? Regards Bill

I am enclosing pics of awning window latches we are trying to find. Thermal Industries suggested you as a possibility for these. Looking for both left and right sides.

PGT lock for plastic casement windows.

Can u please help identify this part Thanks Jim

I received my order for 25 casement locks part # 38-036 and screws 33-072. It seems I cannot tighten the lock to the window. The screws seem to long and leaves a gap and the lock is loose. Any suggestions??

Awning window locking handle with the number 2241 engraved. Replacement could be of a similar part with same measurements. Thank you.

I haven't seen a casement lock yet here with these dimension. Mounting screws 2 5/8" Gap between mount and lock point is 1/2" to 5/8" depending on where you measure it on the taper. Cranks 39-002 and 39-001 fit these windows perfectly, but I suspect that's rather standard?

Looking to see what part this is?

I am looking for 4 levers and casings to match the attached photos. Do you carry them or can you identify them? Thanks!