Viewing all customer Discussions for:

38-131 Truth Maxim Adjustable Keeper

The lever latch mechanism grabs onto three plastic pieces. Each plastic piece attaches to the window by 2 screws. The plastic pieces have disintegrated and that doesn't allow the window to fully seal shut after the lever is moved down. Are the plastic pieces available? Thank you! ... (cont.)

A bracket holding the lock assembly bar on an awning window broke. The house is approximately 20 years and the AAMA certification code for the manufacturer is WND-1 which I think is Window 1??? How do I get a replacement part?

I need help finding the tie bar with 4 rollers. From the top of the bar, the rollers are located at 3 3/4", 20 3/8", 32 3/8", and 38 1/16". The total length of the tie bar is 39". Please confirm these replacement parts on your website: tie bar guide=39-417, locking handle=38-092 RH and 38-091 LH ... (cont.)

This is a lock part from a Jeld Wen vinyl casement window. I need 6 of these pieces. Can you help me out. Thank you

I am looking for the part that attaches to the window the the window lever slides into in order to lock the window. Attached is a picture of the locking mechanism. I need the small plastic piece with 3 holes that is attached to the window.

Hi, this plastic part that locks the window is broken. Could You check if You have one? Thanks in advance. With regards, Andy.

Hi, I have casement windows throughout my home installed when home built in 2005. No identifying marks on them. They crank closed just fine, but several will not lock closed due to broken or missing plastic brackets to keep the locking bar in place or to catch the knobs. Hope the pics help identify ... (cont.)

Hello there!The part you show here looks just like our 38-130 and 38-131 but compare our dimensions with yours to see if they match what you're looking for.

looking for this "casement sash to jamb latch guide. There are lefts and rights as both. Thanks, Jason

Hi, I need hardware for an Apline casement window.

Hi Our picture windows will not close. Recently purchased this home. We need 4 of these plastic pieces for the slide bar to catch to close the window properly. Do you have these? Thanks Kevan

Hello: I am somehow missing one of the plastic parts I am providing pictures of. This is for a left-swing casement window, and is the part that attaches to the window itself and engages the latching/locking arm to close the window. It's 1 3/4" long by 5/8" wide by 9/16" deep and is a hard, white pla ... (cont.)

I need to replace hardware a right hand casement window (as viewed from inside). I have attach a photo of the old but functional left hand window operator, which is stamped "Thuth 31272". I need a complete operator for the right side window. I also need a sash lock, which appears to be #38-091 from ... (cont.)

Looking for these tabs for swisco.

Looking for the locking lug for a vinyl window. This part mounts to the outside edge of the moving part of the window, and is hooked by a pin on the rod that moves up and down to lock the window.

Looking for these plastic parts for my window to be able to lock it.

This is for our house in Hawaii, I believe is is called a breaker. This is what the latch rides up over it give a tight seal when the window is closed and latched. I will need 10 of these.

Most likely from the late 80's Winged Tie Bar Guide ?? Window imprint stamp says = WS-U IGCC reg CBA 12 Latch is on the left - right side swing. The metal bar has three circular nibs on it and they catch the plastic holders on the window itself. And then the plastic on the side window sill is what ... (cont.)

Hi there, many of my windows are missing a few of the multipoint locks. Do you sell them or have a part number? Thanks in advance

Please let me know what you think second request? Thanks