Viewing all customer Discussions for:

39-026 Awning Window Crank Operator

Hi, I have several right and left operators that need to be replaced due to severe corrosion. They seem to match the dimensions for your 39-025 and 39-026 except that the arm extension is 2 3/16" center-to-center. All other dimensions are the same. Also, do you have any suggestions on how to ... (cont.)

I am sending you a picture of an old awing window mechanism. I hope you can identify the part by the picture or it will give you enough information to ask me a question. I also need the handles for Kinko awning windows. (Lawson series 1100). The opener is fine but the handles have stripped out. ... (cont.)

Hello, need a replacement for attached crank and mechanism, i show it as LH Window Crank Operator, 3/8" Hole 39-193 just want to be sure, thanks! John J

No visible #s. Just made in USA

I am trying to find the proper replacement awning window operators. They look similar to 39-026 but a couple of differences the attaching arm is 2 1/2 inches long and it has a 3/8 hole which had a plastic sleeve . The arm has a slight offset. The windows were manufactured by Marva in Puerto Rico bac ... (cont.)

I am replacing moulding around existing windows, but now need left sided window cranks and off white in color. The hole centers are greater than 5" and have no visible brand markings or serial numbers.

I ordered and recieved 2 window operators that loked like the correct replacement. It was real close pu not correct.The item Number is 39-194. The bolt alignment vetically was correct but horizontialy was not with the two screw holes. That would have been fine as I could have drilled anew hole. Unf ... (cont.)

Part #115000-3 Looking to purchase a left and right controller

My beach house has these old horizontal windows on the screen porch. Two of the window cranks have stripped. I am not quite sure which crank would work, so I am wondering if you could guide me. Thanks. Mario

Good morning. My name is Greg and I reside in NJ. I also have a second home in PA in the Pocono Mountains. In that home I have a room with several casement style windows without any markings. The room has a sliding glass door with matching framework and indicates it is an Andersen glass door. The ca ... (cont.)

Hi, I would like to find a replacement window crank operator. I'm looking for a right handed model. The mounting dimensions are as follows: vertical 5-1/4 and horizontal 1-1/8. The overall link arm length is 2-15/16 to 3. The pin to pin length of the link arm is 2-3/8. Please let me know if ... (cont.)

do these operators come with handles,bolt washer and screws? much mahalo,Erik

Hello, Your model #39-026 Has almost all the correct measurements except one. The top hole is not one but two holes spaced 7/16" on center line apart. Starting from the spline side first hole is 3/16 from edge to center of hole than 7/16 from center of 1st hole to the second hole center. Thank ... (cont.)

No markings of any kind found on the parts. The operator is 5 3/4 from end to end while the gear part is 4" from end to end and 2 1/2 inches from hole to hole. I hope this is enough info to help. thanks, bill

Please provide help in identifying part shown in photos. Sincerely David

All specs of the 39-026 seem to be exact except the arm extension. Original arm measures 2 7/16" rather than 2 1/4 ". Will this be a problem? Also, the original window crank seems to be made of heavy steel. Is yours comparable and what would be the shipping charge for 1 or possibly 2 to Rocheste ... (cont.)