Viewing all customer Discussions for:

39-032 EntryGard Dual Arm Operator

Hi, What size screws are needed for the arm operator? Thanks!

I am looking to purchase Truth entry gard 40753 /31538A L - we will also require the R hand identical hardware. Please let me know how to proceed

Seems like the gear is stripped. Will open but not close Randy

All the parts need to be replaced in The Dining room bay window. I am also sending another request after this for another window. Look forward to your reply!Dick

Replacing a crank operator i overtorqued and broke. Window opens on the left and swings out to the right. Existing one said Entry Gard Truth, us patent 4241541, also has 40471, 20810, and 3084IL stamped on various parts. The long arm is about 9 1/4".

Hi, hopefully you can help me out. I have been looking for the replacement of the window crank assembly,the arms are fine. I have been searching for this brand,Truth, replacement parts with no luck. Any information, advice or guidance is hugely appreciated!

Our KK window crank broke off and need to replace the star inside the handle. Do we need to replace the whole crank mechanism?

I hope my pic helps identify the operator. This is a condo development and I am the maintenance dept.If my pic helps determine R or L and correct replacement operator, I can then inventory how many of each I need and I can make an order immediately.ThanksDave

I need to replace two right-side operators, two left-side operators, and one left-side latch (opposite to shown in photo. One of the operators is identified as an "Entry Guard, Truth" with Part Nos. 30841L and 20810 visible. I also need to order one of your Pry Bar and Scraper Tool (#75-081).Thank ... (cont.)

6D5148 on operator arm. Was told they are Anderson E-series windows. Anderson operators do not match.

I am missing the screw for the crank handle to turn for the mechanism. Can I purchase this part.

Looking for this window crank operator and handle. I believe it is an entygard by truth

I need to replace Truth window cranks for a few windows. The numbers that are on the main mechanism (plate) are 30471 and 40264. The gears are stripped and cannot open or close the window all the way. Can you help me get the correct parts? I need 3 left hand, 3 right hand, the covers and the matc ... (cont.)

as shown in the picture, please let me know which part I need replace. Thanks a lot

The short arm on my unit has a upward offset to connect to the bracket on the frame. I cannot tell from your picture if the 39-032 has the same offset as seen in my photo.

I'm needing some guidance on Crestline parts for my casement Windows. I'm assuming I require a whole new assembly (operator?), but want to insure I purchase the correct parts.The longest arm has "Entryguard Truth" on it and the shorter arm has number 20810. I assume this is dual arm?I am seeking ne ... (cont.)

Hi Swisco! I am looking for the entire assembly for this crank out casement, the handle, cover, gear, arms, sliding guides--and all of the other parts I am naming incorrectly! Basically I want to have a full replacement set available for this window. Can you help based on the photos I have suppli ... (cont.)

Caradco window identifying marks are entry guard truth # 20755. The only part I need is the white circular part on the end of the arm. It has worn away due to use I assume. I'd rather not want to purchase the whole arm if possible. Thanks so much.

I have one right hand and one left hand casement windows with the same problem and need to replace the operator(s). Please help me determine the replacement part numbers and prices.The straight arm is approximately 9 inches longRichard

The only markings I can find say made in USA and "Ruth".