Viewing all customer Discussions for:

39-083 Dual Arm Crank, 21-1/2"

Outer screw holes are 4 1/8 on center inside dimensions are 5" wide by 1" high color is white 21 1/2" wide when closed #45002

The housing inside the window crank is stripped & needs replacing. Numbers found were 45002

Hello, I need to replace my casement window arms due to the shaft in the crank coming out. Can you recommend a replacement part? Numbers on the arms are 30895 and 40510. Thank you.

Need assistance finding correct replacement for window crank mechanism. Measurements included in photos.

The crank on our Truth window opener for our Marvin window no longer works. I believe the threads on the main post piece are shot.

not sure if I need to buy the whole assembly as it is just the lever that broke in the center part. the window is from Jen weld Co.looking for center section of the arm assembly.

Hi there, I am am not sure what parts I need to replace this. It is missing the handle and I am unable to get the casement off. I don't see any names, numbers or markings on the existing hardware. Thank you!

It appears that the window crank shaft is stripped where it screws in. When I go to close the window after opening , the crank shaft unscrews with the handle. Is there anyway to repair this? The crank assembly was screwed into the framing during assembly at the factory.There appears no way to get th ... (cont.)

Follow up photos for Emily who responded earlier. Do not see any brand markings. It could be an Anderson window as the slider on the same level floor is Anderson but not sure about window.

I am looking for a window operator replacement with the same dimensions for re-installation.

building from 1992 and I think these are original. I have three windows where the crank mechanism has failed.

Hi,Following up on our phone conversation yesterday, I have attached additional photos of the operator linkage assembly.Could you please forward the submittals for the operator that you provide?Best regards,Steven

Crank operator screw came out of housing and will not thread back in.

I need help identifying this window Hardware. It's an awning style where it pushes the window out from the bottom and tilts upward. Everything else in the house is truth entry guard if that's helpful. I will need the spline and the handle as well

See attached

casement window operator scissor arm

Can you recommend a replacement crank mechanism for this window from MI window and door. It is a 9700 series, c-c35/p-c30

Manufacturer: Truth

BIU

Looking for replacement hardware. Not sure of mfg. 20 plus years old