Viewing all customer Discussions for:

Door & Window

stamped with the codd 1420 (I need 4 total) and I need 12 2630

Looking to purchase window glazing bead to install in the vinyl window tract to cover the screws which attach the window to the wall.

This is a 22" unit. The numbers on it are '21 2 IT CMC 4'.We will need to order two of these.Thank you for your assistance.

We have 2 single sliding doors and 1 double sliding door. We're beachfront and ours have corroded badly.

I have 2 casement windows, both about 20 years old, where the roller/bushing is popping out of the operator track when the arm is cranked out to approx. the center of the track. Do you think it is an issue with the bushing/roller - or something else? If the bushing, is that available by itself? (par ... (cont.)

I need to repair 3 old Anderson windows. My contractor gave me this part - I would need to replace these on my 3 windows. I'm not sure what size to order nor how many I actually need for 3 windows - do I need 3 or 6 parts? Thanks for your help.

I was lubricating my kitchen window (Loewen?) and the black plastic slide fell apart (see pictures). The bar that the slide is mounted on is about 11" long. I managed to get the window back in the hole and it is secured with the window locks. Are these parts available (I would replace both the le ... (cont.)

Need 7 Harvey windows repaired

1. Length of the channel - 25.5 inches 2. Stamp printed on it - 25 5 3. Manufacturer of the window - I think it's Milgard 4. Time of manufacturing - not sure 5. Count of balancers needed - 2

Here are some pictures of my windows, they are roughly 25 years old. There are a few that do not work, parts have broken or rusted. I want to work on replacing parts so windows will work. The upper and lower tracks are roughly 10 inches. The width of picture ending in 354 is roughly 5.25 inches. The ... (cont.)

Need help finding this glaze or a suitable sub. Thanks

I am told that this is an Anderson window. Probably dates to late 1960's when the house was built. I can find no stamps on the part due to rust etc. The window is 36(W) x 53. The existing balance is 6 5/16 x 2 7/8 x 3/4

Hi- Wondering if you can help in identifying this crank for an Andersen casement window. I've not been able to find any numbers/marks on the window itself and not sure when it would have been installed. Please let me know if I can provide more information or additional photos. Thank you. ... (cont.)

Looking for replacement

Looking for replacement roller assembly for older trimview sliding glass doorRoller Only, 1-1/2 Diameter Steel Wheel 1/2" wide 1/4" hole

Hoping you can help me find a match. Fairly easy to get out. Snaps in with the long leg, short leg rests against the glass.

Looking for the replacement hinge on the 1987 period pella casement window. From the inside the hinge is on the right. From the outside the hinge is on the left (Left hinge then?). Thinking it's this part ?: LH 10" Hinge Arm Assembly, Pella Product Code: 39-394 from your website. It's the shoe ... (cont.)

Hello, I need to replace two internally mounted tilt window latches but can't identify the part. Attached are photos of the latches both installed and when removed. Both mechanisms need to be replaced. Can you please assist me?

Dear Swisco, I am looking to replace the parts pictured for 3 windows in the house. Could you help me find the parts and order them? I need 6 of each. Best, Stefano

I just don't know what type of window balance this is?