Viewing all customer Discussions for:

Door & Window

actuating hardware for Anderson casements

Do you have this handle in stock?

Hi, I'm looking to replace four balance pieces. They measure 27" from the metal and have the marking of 2640, BSI, and VT. I included pictures that hopefully show enough to see the distance of the holes where the balance installs into. Let me know any other info you need. Thank you! ... (cont.)

Please advise which channel balance will replace the original one illustrated in the photos. The width of the balance is 1/2". The widow is a non-tilt style. Thank You

Hello, I'm looking for a window roller assembly that mounts to the bottom of a window. The housing is nylon and the roller is steel. The housing is 11/16" x 7/16" x 5/16" (WxLxH). Roller length and diameter are 5/16". Here is apicture of the roller and how it is installed. Please let me know if yo ... (cont.)

I need help to order a couple of these as one has come loose

30 inch channel

Looking for entire assembly. Has number 532 printed on spring

Need complete replacement of this part

Exterior finger grip handle need to replace.

Hi. Do you perhaps have this? I see one close to it but not sure if it will fit.The bubble is about 1/4" round

The hole at the end of the arm was rusted broke. I'm looking for a replacement.

Looking to find quick repalcement assemblies. the track width is 1 3/8" and 1/2" deep. is this enough info to spec the part?

It is a Pella window

This is the identification # on my window: G402-00583-8024. This part is broken, I can no longer slide the window up and down

Sliding window lock not mounted with screws slides into the window frame chanel

looking to replace the crank and the lock on these windows.

Bought home built in 2000. Many windows are without this cover over the lock latch. I think it's driftwood color. the numbers I found on window are G9902BTE

I need a replacement storm door latch for my back door and having a hard time finding one. Please see uploaded pictures.

MFR: KOI-2 Looking to find balances for both upper and lower sash including pivot bars. Upper sash may also need tip out latches at the top.