Viewing all customer Discussions for:

Door & Window

I need the striker/catch plate for the about door lock assembly. We seems we have lost it can't lock the doorThe lock assembly is a Truth Hardware

Hello, I'm looking for a seal for an old metal sliding door. There is one installed on outside of the door and one on the inside of the frame. I have included the measurements on my sketch. You can see one side is molded with v-shape and the other side is L-shaped. Thanks for any help you can offer ... (cont.)

I am trying to replace the rollers on a Peachtree N6819 door....says type BE. Not sure what kind of rollers to order. I have not taken the door off, yet, but the door has two adjustment holes on the bottom of the door. What info can I provide to help find the right roller?

Wondering if you know what kind of window operator would be a good replacement part for the one I have in these photos? The brand is Roto I believe and there are some markings which I have included in the photos. The long arm seems to be shorter (~8.5") than the 11" ones that I have found on the sit ... (cont.)

I need to get 8 of this Channel Balance for 4 Nuair windows. Also I need to see what other parts you stock for the replacement like the plastic spacer that go in the hole in the window edge or top bottom part the Channel Balance locks into to lift the window.

Hi, Trying to identify the correct replacement part for Marvin Integrity Screen Pins in the year 2012. As per your posts could be 70-008 or 70-009? Or a different number altogether? Please advise. Muki

Hi,Would you please help with the parts?Thank you,Thanh

I need to replace this crank handle for my Sunrise casement window as its insides are stripped. The spindle it goes onto has 12 cogs. I can't find a photo of the same handle as mine on your website but was wondering if another would work. The 39-205 looks like it may work. it has an 11/32 inch splin ... (cont.)

It's for to bottom windows the tilt window shoe balance was measure at 1 1/4 in wide 1/2 in deep and 1 3/8 in long

Any help you can give me will be great Both sides are the same

I need some replacement ballasts for my Empire CR-2 Windows. I believe that I need a 23", Series 385, with a 2220 strength. Just wanted to confirm that this correct, before I place my order. Thanks so much for your help! Cheers, Andrea

need to find 2 coils just wondering if you in stock

I need to replace the single spring coil shown in the attached images. Can you please tell me what I need to order? The spring is .5" wide.

1. Length of 21 11/16" 2. Stamped 21 4 3. Mcg unknown 4. Need two balances

1-1/2 In dia dual steel rollers - mail body 3.125" Screw tab +0.44" Flair = 0.825" Frame 1.09" overall height from roller edge to top of frame - 1.78"

Would you people have these vinyl pieces

Window weighs 27.8 lb

Hinge is marked Entryguard Truth 31538A LCasement window has two panels, each with their own lock and crank hinge mechanism.Panel on left side (looking at window from outside) mechanism isn't working right. I can crank window open but cannot crank it shut. I can push it shut with my hand from outsi ... (cont.)

New t-lock balance shoes are thick to go in balances

I am trying to identify this window maker so I can find a replacement part. Here is the serial number WMP 008-1 CAWN CBA