Discussions for Door & Window : SWISCO.com

H-783-LH Tilt latch for Vinyl Window

I am looking for TILT LATCHES for my vinyl widows. They measure exactly 2" from screw hole to screw hole. The entire latch is 3.5"long.The numbers on the back of the latch is H-786-LH on the stationary part and H-783-LH on the movable portion.Anthony

vinyl glass stop

Please advise if you have the vinyl glazing glass stops as per the attached. I have sent pictures of the profile and a drawing that has the measurements.

Coil balance identification

hi folks, this part broke and fell out. The one on the opposite side of the sash has popped out, but I don't think is broken. Could you please help me identify this part and give me any instructions for replacement? Thank you

Vinyl single hung window

Pivot shoe lock needed and tilt lock mechanism 4610100 for shoe lock ---#4 for tilt. I think

+2

Anderson window crank stripped

The housing inside the window crank is stripped & needs replacing. Numbers found were 45002

+2

Left side casement

I was not able to remove at this time, but will if I need to. Truth is stamped in one part. 40942-A is on the part at bottom on frame. This is a discontinued Seaway Mfg window from 1998.

+1

Storm door window clips

these are clips that snap into the channel of the storm door to clip in the storm window

Glass sliding door roller

The roller= 1.25" diameter, 5/8" width, approx 3" housing.

+2

Pivot shoe and support

The plastic pivot shoe broke. It looks like it screws on the side. Simonton window from Home Depot. I have changed other springs and shoes before.

+2

replacement crank needed

Hi, Trying to find a replacement crank i can buy so i can open this window. the operator box is slightly painted over, but reads d-16 i believe, Thanks!!

+1

Help identifying entire mechanism

Hello can you help me identify all part # for this mechanism please, thank you

window crank identification needed

Childcare building was built in 1999 by an architect who had no clue what kids would do to hand crank windows. Of the 32 windows in the building, only 2 handles survived (in the director's office). I need to identify these parts, buy and install.

+2

Jth 3185-

Tru

+2

Broken latch

I have a broken plastic latch piece that I am looking to replace. I am unsure if I can purchase the whole unit or if the latch comes seperate. I think i may need part 90-253 but i am not completely sure. There is a number stamped on the bottom of the mechanism of 45602. Thank you for your guidan ... (cont.)

Replacement for Cmech surface mount lock set

Current lock set is a Cmech ( surface mount). Age 20-25 yrs. Door width is 11/2 inches and is a key dead bolt. Installion requires spacers for lock,latch, and striker plate. Looking for a replacement set in white