Viewing all customer Discussions for:

Door & Window

Hi, your information on balances is super helpful, thanks! I have a window that needs channel balances. Unfortunately I do not have the original balances, they were discarded by a prior owner. I was able to identify that the window needs a channel balance, but is there a way to figure out what dimen ... (cont.)

Hello. Can you help me to find a right part for sliding door please?

Overall length 1"15/16 Width 1"1/16 Thick 9/16

stamped P59 12#26 I would need right and left side

Hi, you would think this would be easy. I will also provide photos but I have a Pella (1 3/4") thick door which I measured where latch is. I'm guessing this is not common because all third-party products with 6 5/8" bolt holes only fit doors 1" to 1 1/8" thick. Why??? Did I measure thickness of doo ... (cont.)

looking for handels

Need a few of these.

hello, looking for 28-inch metal channel 28B weight with clip at top to insert into slot. I would prefer a clip at top to insert itno slot. 1 1/4 width shoe

Pivot bar off a vinyl tilt in window. Long side is 13/4 in long. Small side is 11/16 long

I am trying to find replacement rollers for my sliding glass door. Here is some info from labels on the door. ?Label on side of panel (note SGD = Sliding Glass Door) ?Series M-800/M-825/M-850 ?SGD-R20 ?MST-12069 (00X) ?Manufacturer Stipulates Conformity to ?ANSI/AAMA 101-85 ?M

I am looking for a door roller that seems to be a bit unique. The door frame has "Summit Window" as the manufacturer. The rollers themselves have no identifier. The housing of the roller assembly looks like your 'Reverse Mount Roller Assembly' (p/n 81-141), but the roller assembly within the housing ... (cont.)

Rain sensor

I cant seem to find this part anywhere. I need to replace a broken one on the other side. Could you please help me find it. Thanks

I need the plastic parts for these rivco casement windows. Thank you. Jim

is the 1 inch long Pella screen strike shown in the picture the same as 70-225?

The handle on our sliding glass door broke. It's at least 40 years old and made by Andersen. I've identified a part the may work to replace my Andersen interior handle PN 7147-1 but have some questions on whether it will work. Your part 88-013 look like it may work as the holes are 5 1/2" . The p ... (cont.)

I do need both pieces. The back of the small center slide piece has a stamped number of 537 on it. I believe it is an awning window

Good morning! Someone used a little too much force when closing my window, and the pin inside the handle broke. Looking for a replacement handle but not sure where to start. WIndows were installed before I owned house, thinking in early 2000's.thank you!Alison

Hello, I need some help por favor. it says on it Pat pending. Vanguard. The total length is 8 inches and the length of the body is 7 1/4. Depth in the fatty middle is 1 3/8. It's about 5/8 wide. Thank you. Ray

DOUBLE HUNG, SPRINGS, AND FIBERGLASS RODS, SPRINGS, TOP AND BOTTM PIECES THE ROPE/STRING GOESAROUND . I BELEIVE MID 90'S