Viewing all customer Discussions for:

Door & Window

Need a replacement recommendation for this style handle. Note the high switch position as well. Thank you!

Looking for a top door pivot, stainless steel, for 1/2" tempered glass.

Tried to order a replacement on amazon. It was not an exact fit and would not work. The metal bar is 30". The stamp on it reads 29-5 HP5 CMC 85. I would also like to know if the part pictured is good to continue using or if I should replace it as well while I'm changing the one that broke. ... (cont.)

Please help to identify the part I need. The stamp on the one that I have is 25 3 GP CALDWELL. The length is 26 inches. Thank you for your help!

Hello the 3 sashes at this property are falling forwards from the top. I am looking for a replacement part which i assume is those clips. Thank you so much

Pat. #5,139,291 On the little latch that locks in when slide it into the window at the edge it says 092 The right hand lever says 9E in the center and the left hand says 7H. The rectangle dimensions are 2 11/16" x 11/16" I don't think I have been able to find the exact one but a lot that are close. ... (cont.)

Hey, I wasn't able to find this specific part and any help would be greatly appreciated.

Looking for 2 of these sliding glass door roller assemblies. I can't find any that are 1.25" on that one end.

I am hoping to purchase at least 2 of these and could use your help with ordering the correct replacement. very much appreciated with any help. ThanksMark

Hi I need to replace a couple of these latches that broke on my Gorell 5302 windows. Looks like it is 2-5/16"x1". I'm also looking for the glide piece in case replacing it will help with some drafts I'm getting from the channel.

I am looking to replace the screens for our ELL-1 Series 200 SH/DW(7 12/7 13) windows. We purchased the home in 2023 and didn't realize that all of the window screens had been removed. I've had no luck finding any,so I'm praying that you can point me in the right direction.

I can't find any identifying markings. Is.it possible to replace with a non matching part?

Please advise which handle is a direct replacement for the existing handle which broke off due to fatigue. It is on a hurricane rated sliding door that faces the ocean so it is a very heavy slider. The only identifying marks is WIPI cast into the handle itself. The mounting holes are 3 15/16" on ... (cont.)

I need 2 Alcan window balancers: 18" long, 5/8"deep, 9/16"wide, with bottom shoe 15-029, top 19-005. And 3 locksets 90-180.

I don't know if it's the correct name of this piece. But I need to replace them of all the windows of my home. I need to buy 12 pieces. Thanks

20-4 GJ5 CMC 34 part number on slider

Spring balance for single hung vinyl window. The it is 1/2" wide and stamped 25 4. I also need 2 plastic sash guides

Do you have replacements for these plastic wheels with plastic snap in axels? They are from my acrylic sliding windows on my lanai. They are 1-1/16" diameter and 5/16" wide. I cannot find a manufacturer label anywhere.

The lock is missing on my patio sliding door, I measured the distance between the two holes and came to 3.5''