Viewing all customer Discussions for:

Door & Window

Is this one of your handle sets? Advice on how to repair? Thank you.

I need the hardware that lets the windows go up and down easily. I need two for each window so 12 altogether the picture shows it. Another pic shows the number on the window And one Is the window itself. Thanks for your help.

I need some of these so I can flip and clean window. Thank you, Maria

Very old handle. I need shaft and outside handle. I just ordered inside handle part 40-145 from you it has a 3/16 shaft. Trying to get both handles to fit together.

I need 2 of these

I need Lockholder.

I have two doors each with two rollers marked "Del Mar Eng 448-2."Each roller is comprised of a single steel wheel 1 1/8" diameter. The maximum thickness of the assembly is 11/16". Flange width is 3/4".I am familiar with your 23-043, but would prefer a 1 1/8" wheel, made of steel. Do you have such?T ... (cont.)

I am looking for the spring that secures the lock switch in the lock or unlock position. My door is a Cole Sewell Cambridge Series. Reply email and I will send you a pic of the handle and locking lever. Thank you.Dennis

The left side of the scissor's plastic attachment point broke and fell. I'm hoping the plastic piece shown in the first pic on the right arm is something I can purchase and install from inside. It's a second story window. Thanks!

Hello, I am searching for a possible replacement latch set for this window that the top thumb latches have been broken. The window is secure at the bottom and can slide up and down with relative ease. The only problem is that the top of the window is not secure and will fall into the room. Any solut ... (cont.)

Balancer Number i am looking for is 2130 - BSI -BK

Can you please help me identify the right window balance to order? Please see attached photos. The length is 30-inches length and 5/8 inches wide but unfortunately when I was removing it, the parts fell out due to the poor condition. Weight of the window is approximately 30 pounds. ... (cont.)

I'm looking to order two (2) pieces of what is a pie (corner) cabinet hinge. Can you please confirm if you have or can make this? Thank you.

This a picture of the opening and where the latch goes

I need a pair of Internal window locks due to breakage. The only label identifiable source shows UraPro-Sh written on the truncated label

Purchased a home recently. One of the single hung windows is missing a channel bracket (see second attached photo). The first photo shows the missing bracket installed on the other side of this window. I could not find any identifying information as to the manufacturer of the window. House is 15-17 ... (cont.)

My window fell open forward when window was closed but not locked. I need a part and how to install this. Also why did this happen?

I ordered roller 87-226 slide window roller assemblies which fit but the wheels were too small. My wheel is 1/2" diameter but I cannot identify the part on your website so here are some pictures of what I have.

Do you carry the repair parts for this Kensington Quantum 2 window? It looks easy enough I can repair myself. Thank you

These are springs from a 16-pound window. I would like springs and complete assembly. there is a number on the tilt show.560CSR Pat# 5704165.