Viewing all customer Discussions for:

Door & Window

Twice a year I clean the outside of my windows for the last 15 years. The bottom window is removed so I can pull down larger window to clean the top outside of it. This year on balance came lose and fell behind my building. I tried looking for a serial number on the part but the only number visib ... (cont.)

20years old windows Length -14inch(metal part) Width-1/2inch

I need 2 of these or equivalent for old Windowmaster SH unit non tilt aluminum window.

Hello! I'm looking to replace two kitchen window operator covers and cranks in bronze/oil rubbed bronze finish. Attached are my pictures. They are 'Caradco' but I wanted to forward the pics to ensure I'm buying the right cover & crank. Can you look at it and provide your input?

My hinges require replacement on my kitchen cabinets , I have removed and painted cabinets and wish to put new unbroken hinges however struggling to find some on them read Pat 3613151. Assistance greatly appreciated

Could you tell me product number that I could order for replacement glazing bead that would work to replace some cracked glazing bead in my existing champion windows about 20 years old. Thanks

LOOKING TO SEE IF YOUU WOULF HAVE THIS PART

9/16x 5/8 stamped # 2420 A CHANNEL LENGTH 25"

Hi, Looking for a replacement roller for an aluminum patio door. The important part is the open top to go around the screw spline and the crossmember where to screw mounts the roller from the bottom. Overall length of the roller is not that important. Width and height are.

A client has asked me to get his window operational. I have not been to the house yet, I asked to receive photos of any stickers or labels to identify the window. Do you have parts for this window? Roger

I am looking for a replacement for this door handle. I would like one that has a lock that can be used from the outside with a key.

Operator is marked truth 30905 and 40352. Two screws driven in at angle. Operator is 4" w by 5/8 thick. Jam bracket is marked Roto no numbers. Jam bracket 9 9/16 x 11/16. Sash bracket 7 13/16 x 7/16. Need both R and L versions.

Brushed chrome/metal - has anderson stamped on it. Likely from the estate style. Here is the anderson number:4523-1C

Need help please these are old 1986 windows which part number would be closest to these metal bottom clips 3/8 tube 29" tube length red end Thanks

sash is 1-3/8" wide, channel in middle is 5/8" wide, 3/16" deep sash balance is plastic, 3-3/8", center flat section is 1-1/4" wide

The sweep part is 0.133" thick. I have tried a lock similar to 90-005 but the sweep is too thick (0.15") and won't close all the way. Are there other products with thinner sweep? Also the original part is made of plastic.

I need to ID and price replacement parts for the Channel Balance described as follows: Stamped number is 28C. Length is 29 inches. I need 6 each. Photos included.

H, I am interested in repairing mid-1970's aluminum track slide storm windows. I am looking for corner pieces, latch bolts and rubber stripping (push-in seal strip) lengths if possible. Pictures attached are showing the parts in question next to a ruler. Could you help me identify the right parts ... (cont.)

Need 4 of these, 2 left 2 right.

I have Simonton Series: 40-17 single hung windows. H-R25_48X80. I am in need of several of the plastic parts that holds the coil balancers.Attached are photos of a new part, of a part attached and photos of the information on the windows.Please inform me if these parts are available and the cost ea ... (cont.)