Viewing all customer Discussions for:

Door & Window

Over all length 30" channel 29" markings stamped on channel 60. BG1AX PLASTIC ENDS ARE 1" WIDE the medal hook is 1/4" wide 3/4" long

Unmarked window. Broken Balance Shoe. Possibly from Lowes..

Hi, I need to find right replacement part that I need to order. Attached are the pictures for the part that was in use. The string is broken and need to replace both sides on a up down window where only bottom part opens. Thanks, Govind.

What roller do I need?? Can't find right part. Thank you!

Please I need to replace , this is 29 ' length with plastic wings

Need part numbers for small pieces of weather stripping on the bottom of the vent side of a mid 1980s pella sliding screen door. Two separate pieces. One measures 35 1/8" and the other measures 27". Photos attached.

my unit is 1/2" width and 30" length (not including plastic parts) thanks.

Hello! I'm trying to find replacement brackets for my kitchen cabinets and have hit a dead end. My cabinets are circa 1988 and the dowels that go into the holes are slightly larger than the replacement ones I find. The original dowels are also shorter than replacements so new pegs do not fit fully ... (cont.)

I need two of the channel guides as shown in the attached pictures. The length of the metal section is 32".Thanks,Brian

1.5 inch wheel Part number 41781 Wheel is s&s vb-38 Total width approx 3 inch including wheel Total height of case approx 1.75 inch

Hi can you tell me the part link for these American craftsman windows spring carriers? They have a 7 on them. The springs snapped. I'd like to get the whole carrier with the spring inside it. Thanks!

Metal part is 29 inches in length. Please let me knopw which ones I should get. Thanks!

"19 5 B.S.1 PA" Metal channel measures 19 5/8" long, 1/2" wide. Unknown manufacturer but it was built in 2003 or 2004? I need 4 balances and a few of the plastic take out clips (see photo). Thank you, Travis

Channel is 24.75 long, 9/16 wide, stamp is 24 3 B.S.I. P-O. We need 4 for now.

Please see under subject.Sliding door latch and key lockIndustries, Miami FL, outside and inside pull, Japan, 7 3/16 x 3/4 in. I would like to add outside key to present latch or purchase new latches. I would require two.

Please assist in identifying my window channel balance for replacement. The stamp on my existing window channel balance is B.S.I.2410A. See attached photos. I have (4) each to replace.

Masterpiece Patio Door Lock/latch

Door has no identifying numbers. Old steel sliding glass door. Body of roller - 2.25" Height - 1.25" Width - 0.75" Diameter of wheel - 1.25"

This handle is a near perfect match for the broken Pella handle I needed to replace. However, the spring loaded stopper doesn't quite have enough clearance to pop past the catch on the frame. Is there a latch that matches this handle?

I came to order a new window balance as one of mine is broken but I'm not sure the right size. My existing balance appears to 20.5 inches long with a tube diameter of about 0.5 inches. There was a pic tube which has rotted away of an unknown diameter over the spring. What do I need to replace this? ... (cont.)