Viewing all customer Discussions for:

Door & Window

I'm seeking a replacement for my existing crank assemblies as seen in the attachments.

I have Philips windows these are the nylon rollers at the bottom. They need to be replaced. Thanks

Sir: Do you have the brass posts that secure the swing arm to the slide arm? I have old Rimco casement windows and the brass fitting that secures the slide arm to the swing arm broke off. There is a number "315-01 stamped into the slide arm/ Picture is attached.

I'm Looking for tilt latch buttons for Uniframe windows. These are not surface mount and the "prong" on them that attached to the internal mechanism has broken off. Hopefully new can just snap back in. (?) Also looking for the plastic trim piece for the bottom of the upper window which also has ... (cont.)

need a small plastic piece, about 2 inches long(black on original) that goes into a small track on the hinge side corners, top and bottom of a Crestline- wood inside, aluminum clad outside- casement window. Built 2000 or 2001.Don't know what its called.If you have a schematic with parts list, I can ... (cont.)

Looking for parts for Anderson window

I have 8 large windows with each sash weighing 20 pounds.I also have 2 smaller windows with each sash weighing 13 pounds. The rod length for all the sashes is 29 inches, with a rod diameter of 3/8 inches. I believe that the "Red Tip" balance will satisfy my needs for both window sizes, but I'll need ... (cont.)

I have a Model 108Trapp storm door and need a new handle assembly. It is Italian in brass

JelWen Double Hung window balancer, the window is a JX7

Spring pieces for window are broken windows won't stay open

Sliding doors were installed in 2002. Locking mechanism broken. Says series 2000.

Please see attached pictures of a bathroom window and a bedroom window which is wood and 63 years old.

Hello I went to install my new spiral balances from Swisco, and the attachment point at the top crumbled. To be precise it was a plastic square part, similar to the ones pictured. So, technically speaking, the plastic part crumbled, and fell into the square hole you can see above. I tried to get a ... (cont.)

Hi!We have 9 beautiful Carolina windows with hardware that is falling out one by one. We got a quote for replacing the windows and it would be $10K. And then I found your website so I'm really hoping you can help!Thank you!Lindsey

I would like to purchase an Anderson folding handle for a casement window. I included, in addition to a picture of the folding crank, a picture of the base unit to which it attaches. I do NOT need the base unit, only the folding hand crank. the threads on the inside of the hand crank - or flange ... (cont.)

Good morning,Im Looking for window counter balances for vertical sliding windows and small steel retainer clips that snap into window frame, both items shown in attached photos. The only numbers, names or markings I can find anywhere on the item are(26-4 BA CMC 7) also shown in a photo.Please tell ... (cont.)

These are cranks for crank open windows that are also emergency exit windows. I couldnt find any name or numbers on the crank.

I am seeking for instructions on how to add a hook onto a channel balance.

May 30, 2023Printed on the lower end of the window-channel balancers: 26-5 EL5 CMC 43The five attached photos represent one of two two window-channel balancers needed.Total length of both channels, including the plastic parts at each end: 70.7 cm / 27.83 inPlease provide the correct part number ... (cont.)

The little knob has a spring init and has a flange that flips around and secures screen in place. The known flew off and spring and flange got lost. I'm looking for a replacement.