Viewing all customer Discussions for:

Door & Window

1 1/8" rollers, Width 3/4", Height: 1 1/8", length 3 1/8"

Hello I need help getting the right part form a window. I provided photos, hopefully they help. The balance is 27" long 1/2" wide

Need to replace as the nylon string on one of the balances severed and broke. Markings on the channel balance: 20-4 KC5 CMC 54. Measured length is 21 inches.

Patio Door was installed in 1988. We are trying to replace the rollers as the door no longer moves freely. The replacement rollers that are available at Home Depot & Loews don't fit. Please advise if you carry anything like these

the part i need is the piece im pointing to with my index finger inthe third picture from left .It is held by arivet to the crank armand slides on the rail of the glass window frame Any help you can give me in identifying this part would be greatly appreciated.Thanks Pat Owens

Of the dozen or so windows at our church, only about four will now stay open. They may be of different types, but can we start with one? I know nothing about these, so will need some guidance on both parts and procedures. Really appreciate your help.

Have a bathroom window with pull cords not returning into balancer. Not sure what is the replacement part may be. What I can see on part is as follows: B95 4#19 635. Or it may be B95 4/19 635 not quite sure

The metal part of the balance is 28" in length. Balance is stamped 2720. I need sash guides too. Thank you.

26-5 ed5 cmc 87

I need to replace a few tilt window latches in my apartment. I have not been able to find any.

I do not see any markings on these slide up windows. I have identified the channels needed as 28" 2730 I need12 sash guides

I've included pictures with height, length and width. Please let me know your suggestions for replacement rollers.

I need one of these - can't seem to find it on your website please advise both pieces - the latch and strike the keeper has 2 holes that are slightly tighter than the part with the handle and is in a recessed area - doesn't look anything like your image below (90-326) should I take another p ... (cont.)

I need to replace pivot bars for simington double hung windows. I need 6 bars. Photos with measurements included.

I need new rollers

Jordan Aluminum Windows, single hung, installed 25 - 30 years ago in a small metal office building. Windows are approximately 48 in X 48 in. The balances appear to be 24 in long x 1/2inch wide; can't locate my notes so it's a guesstimate. The windows in question either won't open or won't open smoot ... (cont.)

Need these parts

Hello, I am Kyle Enslow. I would like some help in selecting the correct Sliding Door Wheel Assembly. Please see dimensions below: Assembly Width - 7/8" Assembly Length (W/o tabs) - 2 1/4" Wheel Width Inside - 1/4" Wheel O.D. - 1 1/4" Thanks!!

Good Morning, Need to replacement this Andersen Sash. Can you please provide the correct part I would need to order based off the attached photos? Thanks

What is the length of the metal channel? 31 inches What stamp is printed on it? 31 4 If known, please tell us who manufactured your window and when it was made. House built around 2005 - One of the pictures shows marking from the window I am looking to purchase 2