Viewing all customer Discussions for:

Door & Window

Looking for this keeper for a sliding door. Its a double sliding door. This is the good slider. The other slider needs the keeper.

Hi Can you help identify this part? It is a plastic piece about 3/8" x 3/8". Its used to receive a screw that holds the end of a spiral balance in the window track of my vinyl window Thank you very much

Hello, I'm trying to find a replacement mortisse lock and handle for my sliding door. The original door is from Warhock Hersey and I think the door is model 870 SGD? The sticker is very warn so not 100% sure. I think this Mortisse lock is the right one. Do you agree? Do you have any suggestions for ... (cont.)

What would be the correct replacement for this part? Window is From 1987 or 88

Hi, the door handle & mechanism lock are from Sash Controls. I have included pictures of everything. Can you recommend the model that you carry that would be an exact replacement? Thank you. Michael

This locking mechanism is from an Anderson casement window from 1995 the number on the item is 361902.The window seems to have settled a little and the sash I believe has to be shimmed. Any help would be appreciated.The lock also fits on the right side of the window when you're looking at it from th ... (cont.)

please help idenify

Hello! I saw that you answered some questions on old builder windows, specifically a metal spring non-tilt window. I have been searching everywhere on how to weatherstrip these windows. One specific problem I have is that the plastic piece on the edge of the bottom rail does not perfectly sit on ... (cont.)

I would like to replace the brass look handle/lock with matte black.

Can you help identify this stamp on a title balance ? I have added the manufacture sticker too? Unsure what number is what?

The threads on the inside is warn. I like to purchase the operating unit if possible. Thanks

will mortis lock set 40- 183 fit my storm door . i have a schlage lock set on mine badly damage

Looking for a replacement handle on my sliding glass door. The holes are 3.5 inches apart. Any suggestion?

I have this double hung windows that tilt inward that I need to replace the spiral balance and shoes. For some unknown reason when the window is open about half way and tilted 90 degrees the window sash would not disengage when raised on either side. A close look shows that the pivot shoe does rotat ... (cont.)

the bottom window slides down and does not stay up On the right side of the window there are two coils, the top coil is there but the bottom coil fell to the bottom

Closet door sliding bottom track

Springs are rusty and don't snap back. Metal is 17". Window weighs 6 lbs. Markings are faint but seem to be: DB HO1 16-1 Can you send link to purchase 2?

I have a house full of these windows . Great window I would assume higher end cost wise but no identification on them I can not find this tilt latch . It's a horazontal slide window that closes into it self so the window is flat when closed. There are 4 of these latches on both sides of the window ... (cont.)

ready to install window balance stamp 35DS 37 IMP RB BSI I BELIEVE THE WINDO MEASUREMENTS ARE 34 BY 70 OR 72 BUT THE METAL FROM EDGE TO EDGE IS 36 INCHES PLUS THE TIPS AND 5/8 INCH DEEP

Good afternoon, I am looking to replace two window balances (pics enclosed). The metal length is 28" and the channel width is 5/8". I don't see a part number stamped on the unit. Do you have the appropriate part in stock? Thank you, Marty