Viewing all customer Discussions for:

Door & Window

Do you stock these balances . It's for a single hung tilt window that's heavy.

Hello, Can you help with a replacement for this sash lock. Have four windows with two locks per window. This is on a beach home and these have corroded from the salt environment. Thank you.

NEED TILT LACTH RELEASE LEVER

rollers for sliding glass door needed.

OUT OF MY MIND FOR OLD CASEMENT WINDOW PARTS

The tabs on the window that allow for tilting in broke and won't hold the window in place. Approximately 2" long. They screw in.

Hello, Swisco I ordered your 39-253LB (on order 2028388). I've replace the arm and all is going well. How do I remove the white crank and plate to put over this grey one? Since you're familiar with my order could you go ahead and help me with the cover and handle purchase based on the swing arm I ... (cont.)

Can you help with identifying the right replacement latch?

I'm looking for a door handle and lock that is 5 1/2" screw to screw and 8 3/4" in length.

Cannot find this coil window balancer. ISO 2 of the same coil balancers

Swisco,Looking for balance shoes and anchors. Possibly #5 stamped on cover and coil. Possibly a United 800O series window. Looking outside, this is the left side. Planning on replacing both sides. Unknown, if there is a difference. Five more pictures in followup post. Thank you in advance for your t ... (cont.)

Currently I have a Certainteed glass sliding door with dual point hooks, but no ability to lock it from outside. Can you identify the part # of that handle set? Do you have a replacement for outside handle that has a keyed cylinder (keys included)? Would my current mortise accommodate that keyed ext ... (cont.)

any chance this looks familiar

I have 1965 Skyline Park Model..need new patido door handle w/lock for one inch thick door 3 15/16 hole spacing 82-003 or 82-306 is lock included, i don't understand what the "cutout in the pull" is. Installation guide will be needed...not computor savy if pictures are needed i'll get my brothe ... (cont.)

Hello Swisco. Looking to buy a replacement spring latch for my aluminum sliding window. Please let me know if you have this item available to buy. Thanks Brandon

I've searched multiple stores for a replacement handle that will fit my Getkin storm door. With all the ones I've found so far, the sliver pin is too short and smaller in diameter. The pin measures 3 5/8" (3 9/16"?)with a square diameter of 3/16".from first post to pin is 1 " centerfrom 1st post to ... (cont.)

Hello, I am looking for subject repair small window replacement plastic part, as shown in the attched photos. If you have them, I am sure you have the plastic peg, that fits on the other end of the window frame, that I would like as well. Please let me know if you can help me with these plastic part ... (cont.)

I don't know what type of windows they are. No name of numbers. Measures 2.75"H x 2"D I'm sorry I can't be of more help.

hello, I have a window that is missing a window handle. I was hoping you guys can tell me which handle (based off the pictures) to buy OR do I need to buy the whole window assembly.The arm part of the is labeled HG05 2008U and the casing is op05-7532-00. Attached is the window handle from another wi ... (cont.)

Please let me know what weather stripping part I need to replace damaged seals in my Jeldwen casement windows. Thank you