Viewing all customer Discussions for:

Door & Window

Hello, I am looking for a replacement stop for an IG Unit. Needing a 60'' white very thin plastic stop. Let me know if you have anything close. Thank you!

Hello,I am looking for these plastic weep hole covers. I am guessing they come longer and we cut to size. These are from windows when the house was built in 1996. The latch on the window says Regency. The measurements included with the caliper are an estimate as this one is broke in the middle is is ... (cont.)

Hello, can you please help me find the parts attached from the simonton windows. thank you

Ordered a 40-049 lock for our storm door and it doesn't fit. These pictures are the one we need.

Two photos attached. Length is 34 about inches. I bought some from another vendor about 8 years ago that included the metal fastener not plastic.

I'm having a hard time finding parts for our windows, weather striping and rubber bumps. attached you will find images of said parts

The prior owner of my house installed storm windows. I'm not sure when they were installed but two of them have a problem. The storm window is too small and doesn't connect to the track. In the picture:1 = screen insert2 and 3 = glass insertThe screen insert has closer contact to the track, but stil ... (cont.)

Using the window sticker from the American craftsman window it is a model number 52?80 508 ? WHT. We are looking to purchase six pair of tilt latches. We need two for right now,but we're going to get some for spares this would be for left and rights.They do not have the little tab sticking up on to ... (cont.)

Part # 19010W 3301 Long arm is 7-5/8" with plastic piece on the end. Short arm is attached to the long arm at the middle of the long arm and is 5-1/4", metal slide clip on the end

Can I use this type of pin as a replacement for the Hurd S703 pin? My screens are brown, so I don't want to use the S703 in white. Thank you

Viwintech widow need number for lock and the catch in the drawing

Need help with the correct size. The number engraved on the metal Balance Rod are273000HN. Any help will be appreciated. The windows were manufactured in 1992.Thank YouRhonda

Need replacement for pivot shoes, please see attached photos. Dimensions: Length= 1 3/8 Width=1 1/8 Depth= 5/8 Thank you!

These Marvin windows are about 33 years old. The window operators no longer crank the windows open & shut. One has a number 30842R, the other is 30843L, I assume for Right and Left. The photo has the measurements and part numbers written on the paper.

I have a vinyl tilt window with two broken counter balance assemblies so now the window will not stay up when opened. Picture 395 shows the top of a good assembly. The two broken pieces are completely gone from the window. The entire assembly, from very top to very bottom, including the pivot sho ... (cont.)

looking for a replacement latch like this

I'm looking to buy the plastic covering over the window mechanism. Thanks!

I am looking for a replacement basement window 16 3/4x 28 3/4, with the hinges. As you can see the seal is blown on this one and needs two new hinges.

Hi, my windows each use 4 coil balance springs with a "5" marked on them in the S190 shape/style. Each side uses the double coil supports up top that anchor them and the shoes have the coils screwed into both sides. Can I potentially change these to a single coil support up top and use the same sh ... (cont.)

I am guessing that I need a couple S390-28 2740? Unfortunately the balance shoes are mostly gone so I can't measure them