Viewing all customer Discussions for:

Door & Window

33" channel length

No identifier on the part. The windows were installed in the mid-1980s. The spring is 19" long not counting the loops on the ends.The soring diameter is 3/8 inch.Borden

i need to replace a truth casement hardware for a casement window part # #45035" and 45034. Could you please help. Thanks, Luigi

I need a replacement for the above

I'd like to change operator from right side to left side of the window to make operation easier and safer

The window isn't closing securely. It looks like a part cracked off, but I'm not sure which part is supposed to be here.

Looking fur the hardware

Hello, I'm looking for this part I'm needing for my windows. I can't seem to locate the part on your website. It looks to be a type of vent latch.

Truscon on the bar

I'm afraid the mortise is the part that is missing....the existing handles have the screws at 4 inch center to center and they set back 1 3/8 inch from door edge. I know this is very little to go on but if you have any way for me to accurately get the right part please let me know. ... (cont.)

Hi I included 3 photos / hope it helps. I need a left and a right side spring (one each for one window). Would like to purchase the top plastic piece and bottom pivot piece for each as well. The ones I removed seem to be ok but I don't want to take any chances. The window is an 8500/8501 series and ... (cont.)

Hi, I have a window that I need to replace the valance on. I have included photos of the valance or what's left of it. from top to bottom, it measures (metal to metal) 29"

Need to find replacement door handle for Accuweld Patio Door

I am planning to purchase the Handle (P/N 82-090) and Lock (P/N 82-227). is it possible to install the above SWISCO handle and lock to in the same position/configuration as my present lock shown in the attached pictures; specifically the position of the Offset. Have I selected the right replacemen ... (cont.)

Looking for adams rite mortise for entrance door. Length 6 3/4" by 1" width.

84-020 will this roller replace 84-070?

Good morning! I am looking for the L & R versions of the pictured pivot bar. Is that something you can source for me? Thank you!Faith

I need a window balance (2) for a held-wen vinyl side release window. The balance on the window is marked 36-6. Can you help?

Only name I found on any part of the window was GA on the center up/down lock. Looking for replacements for left and right tilt latches. Screw holes measure 2 inches from center of hole to second hole. Total length of latch is 3 inches x 1 inch width.

Just wondering what part I need. I need like 16.