Viewing all customer Discussions for:

Door & Window

hi see attached pictures. these are for a Traco window, Sienna 4600 series, double hang. I guess the coil housings serving the lower slide window need to be replaced on both sides. Hope this helps identify the parts, pls let me know if u need more info Thanks for your help, Alan (quick lerner, hom ... (cont.)

I see you have a snap in glaze seal for windows. Will your product replace the brittle pieces i have? Thank you

This is the plastic trim at the bottom of the window. It seems that it could be replaced. Thank you so much!!!!

i am looking for a double window cranck mopen out to left thanks Rick

1. No PICS, yet.. 2. Aluminum Handles/ Wood insert, interior handle only. Screwholes @ 4" C-C. Latch Lever @ dead center of screw holes.. 3. Latch Mounting holes @ 3 3/4" C-C. Latch Slot @ 90* (horizontal to vertical). Latch Body width @ 1/2". 4. NO identifying numbers, marks, etc, on Visibl ... (cont.)

similar to 90-005 looking for a sash lock with 2 1/4 installation holes but with a 5/8 locking tab

Hi, I have a 3 panel sliding patio door on a lanai. Manufacturer was "Florida Extruders International" and it is a "Series 1000". Each door has two, single roller units on either end. Looking to find a replacement model. The picture shows the parts I removed. One part has "D-1106" printed on it. ... (cont.)

Hi... I am looking for replacement weep hole covers in sand for Ply Gem Insulate 400 Vinyl sliders.

Markings are 29DS 29L

Please can you help me we're can I get this

need latch ass, & window stop levers, you sent the latch before. Storm-door is part#030105 90505 7979

This is a sliding glass door built by Milgard windows would like to get the lever and latch for sister's home was built in 2002 if that helps?

The part is stamped 2730. It is 1/2 inch wide and 28 inches long.

Looking for replacement rollers for American Craftsman sliding door

ANY CHANCE YOU COULD HELP ME FIND A REPLACEMENT FOR THIS ITEM?

I have ordered some sash pivot bars (26-241) from you but may need the plastic piece that the pivot bar slides into, located in the jamb of the window. Unsure of the manufacturer of window.

I am hoping to replace the storm door mortise latch on what I believe is a Sears storm door about 30 years old. The dimensions on your model 40-194 seem to be the same, but the opening for the thumb bolt/lock is not the same. My door has a rectangular piece in the same location, and fits into a cir ... (cont.)

I have a standard PSH iron gate lockset on three gates, and I would like to replace them.

The house is in Florida, 6 years old. Vinyl windows with impact glass. One balancer cord broke. Stamped on the metal is "28DS 37" The metal channel is 30" long, 9/16" wide. Can you help me idenify this?

Looking for a replacement pivot bar with exact hole placement as the one shown in my picture.