Viewing all customer Discussions for:

Door & Window

Hi, all I know is that it has 2 coils and there's letters A-F. The top one has D in the upper right and the bottom has H in the upper right. Let me know if I need to completely unscrew and remove it. Thanks!

Hi, I would like to identify the PN for the attached window balance. It shows "14 5 ew cmc 10". it is for a non-tilt window Thanks,

The sliders are old but in very good condition so I'm hoping to find this replacement part. The inner handle is fine, I just need the part in the photo.

I need balancers for both sides of this Milgard Classic single hung. 26 4 AW CMC 7

Alliance Windgate Belmont double hung window broken pivot window shoe I need to replace the balance and shoe

30" length(metal only) and 1/2" wide left side channel balance marking is 29-4 BA CMC 11 right side channel balance marking is 29-4 AA CMC 11

Per the associate I am working with, she said the blue end attachment is signs this is a custom.

These came out of an Alliance window and I need both L&R. The only marking I can find on the whole balance is the leter P. I also need the little part that screws into the bottom of the window that sits into the balance and the 'stud' has broken off. I uploaded some measurements for that piec ... (cont.)

Please see pictures attached. Do you have these metal spring clips to hold window balance in jambs

1st picture-shows window label 2nd pic-pivot shoe or lock (not sure the correct terminology) Also need the coil springs that run from center sash side to bottom dash side. Need internal tilt latches R & L

Half inch wide with the markings 16 2

Not sure of the brand of the windows. Located in Michigan and 22 years old. We have 5 total with 4 acting up

Latch cover must match locking mechanism . You sent me one but it doesn't match or fit ?

Hi, I'm inquiring if you would have a replacement part for my window coil balance. Please see attached images. I would need both the right and left balances. Thanks, Rob

No number or letters looking for a replacement

Hi, could you help me to check if you have this type of clip available? Thank you!

My springs are shot. The window width is 37" and weighs 23 lbs. I see no identifying numbers on the springs. Looking for coiled springs and pivot shoes. The shoe measures 1 3/8H x 1 3/16W and is 9/16 thick. Can you identify the parts? Thanks!

Do you recognize the attached window opener? I need to replace a few that are broken and I'm having trouble locating them.

The notch or lock does not lock need new part

The height is 10 inches at the high point. 9.5 at the low point.