Viewing all customer Discussions for:

Door & Window

I am looking for replacements for an Andersen Window Balancers. I saw a previous post for one that was stamped 11600-17, which is what mine is also, but you needed additional information. The other stamp says J49 512 4 88. Thanks for the help.

clear plastic clips with thumb screws that hold the storm window in place and also the screen in summer. My door uses 10...3 of which are broken...I do have the screws...1.25" by .75"

The house is old and I see no markings on the latches. Can you help?

Hi there. I have storm windows where the 'nub' on the corner pieces has broken off so the window no longer stays in the channel. Attached is a photo so would you be so kind as to confirm which replacement part I should order? Thanks for your time and assistance. -James

I will like to buy a handle to replace the one that we have, can you please help me choosing the right one. The manufacture of the door is naidraug, and attached are the pics of the handle, the separation btw holes is aprox 4 inch thanks !

Need to replace lock part of patio door or to replace the whole thing including the handle. This door is from 60s

I have Vinyl windows (manufacturer unknown). There are no takeout clips installed or slots to install some. Cannot install a balance without takeout clips. How to resolve this issue?

I need some shims for a set of Jeld Wen window 'wen-lock" stlye latches. I was referred to you from Jeld Wen. Please advise

Need to replace a existing lever lock set with a nob lock set with the dimensions the same as your product code 82-400. Installing plantation shutters and the lever is in the way. Look forward to hearing back from you and hopefully you can help. I'm not a carpenter just a do it yourselfer. Thanks. ... (cont.)

Help looking for a replacement

I need to replace 4 Lawson window balancers stamped 29DS 38

The lock was stuck so I have to break it and replace the handle

Markings are 19 3 (BS1) and 25 4 (BS1). Metal part is 9/16" with a length of 25 11/16". The top is 1/2" wide, 1 1/4" tall, bottom shoe is 1" deep by 1 3/8" tall. The 19 3 ones have a window weight of 12.4 LBS and the 25 4 ones weigh 20 LBS.

Hi I need help identifying my bottom window channel balance. Hard to read but the info on the back looks like: 29 1 FO CALDWELL I measured 30", excluding the plastic attachments. Photos of both ends of the plastic attached. Thank you!

It came off the bottom of the double pane window panel. There is one on each side that sits in the spring loaded slide pieces. Not sure of the window brand but there is a number on the piece shown in picture. I need a left and right side piece.

APROX AGE IS 1985 I THINK. UNLESS REDONE AFTER HOME BUILT.

Hello,The window I have is a 2010 Corell 5000 Series single hung white vinyl.I'm including pictures, but am hesitant to remove the existing broken part until I am sure I have the right replacement. Window continues to open and to hold in an open position.Pictures include the window, the broken coil ... (cont.)

i dont see any on the site that look like the ones i have

This is 29" from one end of the metal channel to the other. It is for a 36" x 36" dual pain aluminum window. There is no stamp on it but there was an ink marking that might say 28C but it is very hard to read. I also need some of these for a 36" x 48" window. I couldn't figure out which model is ri ... (cont.)