Viewing all customer Discussions for:

Door & Window

I am in need of 2 casement window operators one right hand one left hand. windows and operators are identical and mirror images of each other. both have one arm out of the operator and have a shorter arm connected to the window sash from the frame. Some identifying features include; etched into the ... (cont.)

Should be easy for you guys to identify.

can I get a balance 770 series D with a hook on the cord end 62-105 How much would it be in quantities of 10

need right and left lift (balance). They measure 23 and 7/8 inches long at the metal channel which is aprox. 1/2 inch wide. It is coiled spring with block and tackle arrangement attached to bottom metal hook. See picture. Stamped on the metal channel is the marking "2360 BSI vc. See attached 4 pictu ... (cont.)

The mechanism in the crank for the window has failed. There is nothing for the handle to grab onto. I hope this part can be replaced. Pictured is an intact crank mechanism and the one missing. Thank you.

I'm having difficulty finding this part - I'm hoping it's available as one piece with the tilt attachment The metal measures 27"

I am not sure of the brand. Thought it was american kraftsman but there customer service line says those are not their part numbers. I need to figure it out. I need 8 of the pivot latches, the silver metal piece shown above with part number 8254 printed on it and I need 4 of the night latches the ... (cont.)

My name is Luz I want to know if you carry Marks security locks I'm inkling a picture of the door.thanks if you do please send me a link of how can I buy it.

Help -I think I need a Series 795 cross balance. 34" new. Old one measures,(34.5"). The "T" on end measures 1 1/4". Sash weight is 30#. The screw holes on the "piece "that mounts to top of Sash,measured 1 3/8" ,( center to center).& the screw plug,(26-200),+ the screw; for TOP mount. I ... (cont.)

Hey again, Looking for the pictured patio door roller but the wheel needs to be 1 1/4" NOT the pictured 1 1/2". The casing is 3/4" wide, 3 1/8" long, 1 1/32" high. Thanks, Erik

Appears to be a vinyl pivot retainer for my double hung window. Can you help?

I have a storm door without any identification , it is not in place and has no hinge pins. I have tried the replacement hinge pins with springs that you recommend to others , but did not fit. They were too big. I believe it is a larson f cranb 36" 350-13 . Any Thoughts?thanks so much Barry ... (cont.)

Have an old slider from early 60"s measurements kilian name on roller, syracuse, ny 1 5/8 inch diameter roller assembly 2 pieces adjustment piece 1 7/8 inch roller and assembly together 2 7/8 inch 2 1/4 inch without roller 1 1/2 assembly togeter 13/16 thickness or depth

I need hardware for a sears best storm door photos next

The windows were installed in 1976. They are Mayfield or Mayfair. I need black vinyl window glazing, about 100?.

I'm looking for a latch for an old Norco window. Note in the attached picture that the latch fits into the cutout on the wooden window grids. Thanks for your help.

What is the correct replacement for this balance?

I need 2 replacement handles for 2 of the same sliding glass doors.

Hi,I'm trying to get a replacement part for this Pella window.Please advise. The crank is threaded so we can turn to have the window open.Thanks,Kathleen B.

This is the plate we need to order. Just the plate.