Viewing all customer Discussions for:

Door & Window

NO MARKINGSMETAL PART IS 22 INCHES LONGBACK OF CHANNEL IS 1/2 INCH WIDE.THANKS FOR YOUR HELPMARK

I googled the U.S. Pat. 3.041.657, which has No. 454 above the 3/4 front and 1 3/8 rear with a rounded/convex edge wheel and was directed to Swisco part #23-031, which has No. SBI above the 3/4 front and 1 3/8 rear with a squared off edge wheel.The conversion of U.S. Pat. 3.041.657 did not work beca ... (cont.)

Hi, Please let me know which part number of snap-in vinyl glazing bead (refer three picture above) for my (7) windows. Let me know if you need more information.Thank you,Minh

Window Series# 1400 Superseded by #660 Window ID #00752517 Referred to as a Balance Shoe or Pivot Lock Shoe Part # 6602BAL SHOE/00000 (000011100)

Hello, Looking for a match on the attached photos of window glazing. Thanks

Tried to up upload pics could not.Company republic windows now out of business looking for 4 balancers 24 inch long.Please tell me why your site would not upload.Thank u

My lock broke and fell down the side of the door. I picked up a new one at local store but it isn?t rounded and wiont install. Wheee can I find this? It?s 3/8? wide

Looking to replace the handle for our acorn screen door. Please see the attached photos and let me know your recommendation on which handle to purchase. Looking forward to hearing from you.

The old balance is marked: 26 4 JK CALDWELL, length of metal is 27 inches, weight of window is 26 pounds. Width of metal is just over 1/2 inch and the higth of the shoe is 1 3/32 as described on your website. Based on this information is the correct balance: S385-27 Option 2640? The 26 in the balanc ... (cont.)

exterior windows snap glazing

I need to replace several of these tilt in latches on my windows, The latch measures 2" long by 1/2 inch wide. The 2 pieces that break off on the underside are about 1/4 inch between the 2 plastic pieces that fit into the window sill.I believe these windows are Certainteed windows from the late 80 ... (cont.)

I need replacement parts shown in above photo. This is the slider that allows you to remove the window from the frame when the window is in the horizontal position. When in the vertical position it retains the window. The data in the subject area is from the sticker on the window frame. ... (cont.)

I need a replacement awning operator. Casting number is 45142, and according to my customer the measurements from the mounting base to the fully extended arms is 12 3/4". I believe he means from where the arms reach through the PVC window.

I need a quote for (50) 1840 window balances with the 15-003 shoe please.

Hello, Got two broken window locks that need repairing. Unfortunately I don't know the brand of windows. I suspect they are the wabash vistarama? Any thoughts/ideas? First photo shows the intact lock whereas second photo shows the broken handle.

Latch needed

The handle is fine the only part I need is the lock and the inside locking lever The door handle is a sash control 2265, are there replacement parts available? Thank you, Linda

I have Arcadia sliding glass doors from 1973. The locks are broken. I need to find replacement parts. Also need to replace ball bearings/wheels. Please let me know if you can assist.

Only identification number is 30866 on arm. Truth logo on the other arm.

I ordered and received from you some replacement take out clips, part no 16-002. I am replacing a take-out clip that is broken but still in place so I need to remove it and insert the new one. Is there a procedure to follow to do that or any tricks you can relay? Thanks. Bob