Viewing all customer Discussions for:

Door & Window

Looking for pivot bars for my Alside vinyl replacement windows, photo attached

Crank is stripped out ...it has a number 31997 and printed Delmar Toronto Truth I need one of those and 2 latches

Which handle will fit the 8-1/4 x 1-1/16 slot on my glass sliding door (with aluminum framing). The exterior handle is a pocket, the interior handle is a pull that Mont?s to the flat aluminum frame.

I have a triple slider from MI and I am in need of new upper plastic guide rollers for the top of the middle sliding section. The channel is 1 1/2" wide and the plastic rollers fit in the top of the slider at each end and are held in place via a plastic pin that slides into a hole in the top of the ... (cont.)

I don't see any markings to identify this part, but it is the part that you slide left or right to tilt window in. Located near the upper left and right sides of the lower window pane.

I just purchase my home an need to replace this lock . But instead of the gold want the polished crome

Hi. I installed the new truth casement hinges 2-14 opening, but need the parts to connect the hinges to the underside of the casement window. Under the window to the far right are three holes about 1/4 apart with one hole above the three. I need parts for left and right windows. Theses are Patriot c ... (cont.)

The latch won't move out of the door and I no longer have the key. Would it be best to replace the entire assembly, and if so, does Swisco sell them?

Second set of pictures. One more email is coming

I'm looking for the pieces with the crew and blue piece that plastic piece that the window slide into with the spring I dont know the make of the window that's my problem tooI need the plastic piece and the spring its 5/8 wide length is 29 1/4 can you help me

Entry Gard Truth

Can you supply this operator? May need several each right & left. Vertical hole spacing 5-1/4", horizontal 1-1/8", end link is 2-3/16" c-c w/10-24 stud, uses screw with shouldered plastic bushing, bushing OD 3/8". Main gear arm is 2-5/8" c-c, end link is flat. Prefer white housing. Could probab ... (cont.)

can't identify part but has 2 wheels per roller. Jeld-wen door, I think?? Image is of the stripped screw that regulates the balance of the sliding glass door. The door is heavy. It has 2 of these roller adjustments on the side (not end) of the doors. Thank you.

Is your hinge a 1/4 in overlay? Thanks. Eve

I need a left side arm for a casement window. How do I measure th correct size? Thank you.

I have the same issue as the above post. My crank handle broke off and won?t close window. Do you still sell these?

I am trying to find the correct replacement balancers for my 3 windows. 2 are the same size and one is smaller. They are from milgard windows.

Will the snap-in glazing bead work on a Norco window?

Hello,Does this have another model for doors that are an additional 1/2 inch thicker?Is 82-302 available for a door that is 1 1/4" thick? If so, would it be compatible with the 82-002K set

I need a few sizes of balance for Milgard vinyl windows one is H-LC30-48x78. Some are smaller but if you have the replacement parts i can get the correct sizes that I need to you for the order.