Viewing all customer Discussions for:

Door & Window

Thanks for reaching out. I have three windows that will not stay in the up position without some form of a prop. They are Pella windows but they do not display any model numbers. I assume it’s so sort of balancing hardware that helps with staying in the open position. They are the same ... (cont.)

I am looking for a door handle replacement for my storm door. The Serial number i have is 2878901. Do you a door handle for this storm door? Thanks

I have 8 casement windows with screens in a sleeping porch that haven't been opened in at least 40 years. All the operators need replacing--they are so rusted/broken and dirty that I can't find a mfg mark. And the windows are swollen with humidity and painted shut so I can't show the part in fully o ... (cont.)

I need a quote for the S751 ribbed balance 39" long but for a sash weighing 20 lbs. The existing sash is stamped 36HDB. I will need 4 of them. I am also going to order parts for 4 more windows but will not need a custom order for them.

This handle is needed for my deceased mom's house.

Looking for bottom sash guide

Was looking online for this older style of snapin and this was the model i came across. This was the model i found Alenco Window Snap In Vinyl Glazing Bead 65-190B

The crank housing is stripped out on two windows. The guide is 26 1/4" end to end. The window opens about 9 1/4 inches. The two arms have the numbers 40011 and 40012 on them and the crank has 45199 cast on it.

Where can I get the similar part of the photo's attached

This has "Production Ent Hileah FLA" stamped into the side of the housing. It's 1/2" wide and the outside housing is 1-7/8 to 1-29/32" long. The roller is 1-1/8" in diameter.

I need some help on identifying this part for my swing case wood window. I bought this house recently but the house is probably +30 years old. Any help would be greatly appreciated

Looking to replace this whole system. There is a 9 on the coil and it is a 1/2 inch. Also the the width of the white thing is 1 and 1/4 inch.

Stamp is bsi 31 6. I will need 4 of these

Looking for these window cranks and the wood pieces that fit over top.

Looking to replace these window cranks.

Length is 33 7/8 width is 1/2" I see a mark (pictured) FO4 33 TGX

25 5/8 metal channel length. 25 3 pc stamped on channel. Milguard window. House built in 2006.

Cabinets are not closing properly and they have become misaligned

All marks are in photos. I see 20810 on the piece that connects the bracket on the window to the elbow shaped part of the mechanism that attaches to the window frame. P30842 appears on that elbow shaped part. The window opens on the right, crank on left. I took photos as I measured all pieces. I wa ... (cont.)

I need the screw and paw that secures the cylinder lock.