Viewing all customer Discussions for:

Door & Window

I am trying to identify the clips which attach to the window. These are migard windows, single hung, opening upward. I just received the new balance bars to replace (S350-27 : 27" Series 350 Channel Balance). When I installed, I found a couple of the windows wouldn't engage the window. I found t ... (cont.)

Hi there,I need a lock cylinder for my Pella 450 series hinged patio door. The handle and other hardware are fine, but no lock cylinder came with the set.Thanks,Kim

Looking to replace some right handed and left handed crank assemblies on my semco windows. Do you have somthing that will work?

Hello,I am looking for both a left hand and right hand operators. According to the Truth website I need a 15 Series, Dyad Operator, Model 15.30.Do you have those available?Thank you,George

Hello We've been trying to replace our patio door handle - Sash #2665 and I guess you can't just go out and buy a new one, any kind - it has to be the SAME EXACT one that came with the patio door, according to all the hardware stores I've visited. I find that so shocking. At any rate, maybe I'm t ... (cont.)

I'm looking for the handle for my security door lock. The rest of the lock is still good. The lever of the handle broke off so that is the only part that I need. I think this part is made of a pot metal. By looking at the picture in this discussion the part is B for the door handle. Your help is de ... (cont.)

I am looking for a new window crank. Inside my existing crank the model number read 1RH 18-0821. What would you recommend as a replacement?

I am looking for a window latch and crank for our bay window. Thanks.

US Patent 4505601; Canada 1986; UK PAT.2135397

Hi,The circular piece that runs along the corridor on the bottom of the window is frayed and worn. The window will not open and shut like it should, and I believe this is the culprit. I think that I will need to replace this part. Can you help me? My window has the NORCO WINDOWS model description #: ... (cont.)

I need the groved nipple that the handel goes on

I have 1 wheel on a 81-154 frozen. Can the wheel be replaced or does the whole roller assembly need to be replaced?

I need to replace this part for my patio sliding door. Can you help me find the right part

Also do you have the felt weatherstripping for the window the window measures 30"wide by 23"

I measured this guide as you say to do on your website it came to 21" and is 1/2 width. There is a stamp on it marked 21 c bsi. I cannot find any manufacture or other markings on window. The spring busted on the other guide i would like to replace both. The house was built in 1987 if it helps. I als ... (cont.)

Another handle has Norco printed on it. I'm looking for the rectangle piece and window crank if you can help.

I purchased this handle but I'm curious what the screw is for? It doesn't seem to secure the handle to the operator; is it supposed to?

Mastic pivot bar

Is your flat spline interchangeable with the flat spine used on my Anderson 4000? and any tips on removing the original flat spline?

I'm looking for a replacement handle