Viewing all customer Discussions for:

Door & Window

In the first picture the threads are below the sill. Need an extension. In the other 2 we are removing the wooden sill and replacing with granite which will make it 3/4" thicker so need extensions for those 2 Windows. I measured these as 5/16, 12 teeth. Also need the hoods that are missing ... (cont.)

I know this part is a pivot of some sort and it has a nipple piece on it where the spring in the second picture pulls down and hooks to it

Helllo I need a new tilt switch. I included picture. As far as identification all I can see is the following in various areas: E 9L 092 Pat. Pend. 5,139,291 I also both my pivot bars split. I unscrewed the screws but the pivot bar will not come out of window. The sash end loo

The screens have 2 posts at the top and plastic slide clips at the bottom and fits inside the window frame. Is there some sort of handle that can be installed at the bottom of the screen on the frame? My house is 2 stories and it is hard to put the screens back in from the inside by just holding ont ... (cont.)

Please take a look at the following images and let me know which replacements will work for me this is for an apartment complex

Was cleaning the window and the coil on one side broke. Not sure what brand it is but the serial number is 053-618554. The manuf date is 9/8/04.

I have Peachtree non-tilt windows that need new balances Glass: G1188 Window balance: stamped 2436 (l=14.25?, W=0.5?) Qty:4x2 Glass: G0688 Window balance: stamped 3654 (l=23.25, w=0.5) Qty:2x2 Glass: G0788 Window balance: stamped 3654 (l=23.25, w=0.5) Qty:1x2 Glass: G8802 Window balance: stamped ... (cont.)

Double hung tilt out window bracket

I need tilt-latch for vinyl windows replacement parts. It is 3 3/16" long, 1 5/16" wide, 5/16" high, and about 1 1/16" hole-to-hole. I can't find them online.

These windows were installed over 25 years ago. I am looking to order part 26-107 and 26-116. I am struggling to find the tilt latch replacement, photos attached. The latch on top is 2 inches long and .75 inches wid, pictures 1 and 2. Picture 3 shows the thumb latch removed and showing the inter ... (cont.)

I'm looking for 5 left and 5 right pella white architect series casement covers. Any ideas, besides pella for $32 each...

I need 24 pins like this and 24 spiral balance plastic slides with the cast aluminum receiver so the spiral balance has something to attach to. Thx

I'm curious it is the differences between length of the top and bottom sash if marks on them are the same?

Do you have something like this? Approximate measurements are 1/2? width and each wing length is 9/16? long. Angle appears to be between 30 - 45 degrees. Thanks.

Hello, I am needing two sets, or four slides. The length with plastic end is 27 inches width is 9/16 and depth is 5/8. Length of metal end to end is 25 1/2 inches

The nylon bushings that hold the swing arm have snapped the rivets. Can I get 2 sets of bushings or even arms for this style window

I need to replace 27" sash balance labeled 27DS42

No names, numbers or markings found - except I think a "1"??

latches on each side of the window to keep it open a little bit. You can have your window open, but not far enough for burglars to get through.

i need the part or a replacement i will be apresite