Viewing all customer Discussions for:

Door & Window

Help me find a replacement channel window balance part number on 28B USB.

The manufacturer is Atrium Aluminum Products, window series 775. The home was built in 1998, and I need to replace each window's snap-in check rails - the part where the bottom part of the upper sash and the upper part of the lower sash come in contact. I have seventeen 3' wide double hung windows ... (cont.)

Hi my channel balance has no option # , It dose have 20 3 BSI OJ . I would like to order 20 series380 channel balance . I need 6 /20 series 380. All so need 6 window stops , I have broke a few . Please let me know About Option . THANKS Fred

I only see a # 59 And L 1 on the bottom

I need (2) 17" Spiral Balance 9/16? wide. From the tip to the end about 2? Your foot # 15-009 looks to match my photo.

Hello my name is Fernando ,and I am looking for a balancer for two windows ,the two first pictures are one of the windows and the others are a diferent home but same type of window, is no more info I can supply, as far as I know, the construction company name was pulte,and both houses was build in 2 ... (cont.)

I am in need of a left and righthand replacement. The broken pieces measures 3-1/4 inches by 1-3/8 inches. On the underside of the lefthand part are the digits 535-A (rectangular piece) and 536-B (mechanism). Digits on the righthand part are 536-A (rectangular piece) and 535-B (mechanism). ... (cont.)

Sash Controls Handle (1060-1943) holes are 3 15/16 apart White in color.

26 inch long by 1/2 inch. The window go up and down.Thanks.

Our tilt latches measure 2 and 5/8" long, not including the tab; by 5/8" wide. We find no brand marking on the windows. They were installed when we built the house and are 12 years old.

Windows installed in 60's/70's. The only marking is inside the housing- "made in USA"

Please help me ID the replacement part for my upper double hung window. Thanks. 28 inches in lenght

Hello, I have 2 mirrored Stanley sliding doors for a 48" opening. We no longer have the tracks or the associated installation parts to make the doors active again. I provided a picture of one of the doors. Looking at the door and it?s rollers, can you please help identify the following: 1) ... (cont.)

Looking to replace a few of these operators

This is the window shoe lock for the balances. I need 40 as they all broke! Can you believe that? 40/66 are broken. I can send a pic if that help. Plastic is green and the base is 1 inch wide

Hi I have been trying to find these rollers for a few weeks and ordered a few from you guys but they are slightly different in a very small way so I took pictures as best as I could to see if you can help me out ......I also need these rollers too

Please help. Looking for least expensive option that will work well. Attached is a label from inside the window and profile of the glazing piece. Here are some measurements: Flat: 3/16 Trough: 1/8 Rounded section (straight across): 3/4 Full diameter: 7/8 Need the following lengths (t ... (cont.)

Do you have replacement window spline for the attached photos. Thx

Hi can you please help me identify the right replacement product?

I will like to buy this unit. I can't find this unit can you help me thank you