Viewing all customer Discussions for:

Door & Window

looking for replacement part

u.s. pat. 4,241,541

Does the stamping "34 3 DQ Caldwell" help in cross referencing the right part for my window? I need 2 balance rails.

Masterview Window roller photos and measurements

The number on the latch is 11196 right and left. I hope you can help. The company where we bought the windows is closed.

I have a 28" window balance and nothing left but casing. Only # on the balance is 2730. Any help would be great. Thanks!

Hey my name is Mike, I need to locate series 795 channel balance 18in, it's the same as pictures home owner from Huntington Pa September 14 2011 can you help. It's a NAMI sash window double hung slide and tilt. Thanks Mike....

1/2" wide Non-Tilt Window 28" Long Thank you!

I thought I'd ordered the proper top sash guide from you but the screw hole is too short attached is a front and side view of the guides that need to be replaced

how can i figure out if the 40-213 will work for ne

Is this weatherstripping available? Did not find on website. It goes on the bottom of a window sash at the sill.

Handle picture measurement: 1 1/2 and 4 and 1/4 inches Door picture measurement showing broken handle: 1 1/2 and 2 1/2 inches. What would be the closest handle you have to replace mine. Thanks

Which is your part # for this pella operator? Pella's part # is 0B1V0001 LH The window is stuck closed & can not be opened. Going to buy an operator in case it breaks once opened. Thank you

I can't seem to find the right spring cover, the one I have measures 1 3/8" high-1 1/4" wide, and 9/16" wide, will also need the right barrel for that as well. All the ones i see are almost an inch deep, not sure if those will work. Hopefully the measurements will help.

Hi. We need enough of the gray vinyl snap-in to finish our one window pane.Horizontal is 23".Vertical is 14 1/2"

Hi I'm trying to find parts like the ones in the photos. I have no name or numbers to identify them I was just wondering if you had anything similar. Thank you.

I have up down sliding windows. Need balance for two windows. Don't know series.

Looking for two of the translucent plastic part pictured for two Certainteed windows installed around 1994 or so. Thank you so much for your help! Jennifer

Handle has 4 parts front handle ,plastic part in middle ,lock and outer handle...marc...is this a citation handle?

I have a couple of beige Traco windows that have bad tilt-out latches. The length is 2 7/8 inches, 3/4 inch width, and 5/16 inch depth. It is beige in color. Do you have a replacement part. The top picture has the latch on its side between a knife and a pen.