Viewing all customer Discussions for:

Door & Window

1. The opening (for gear bore) is about 3/8 inch. (Photos are, Imag0992 and Imag0993 2. The photos (Imag0990) showed the dimensions. 3. I cannot find the logo of Anderson on the casement window.

Hello, I ordered some new weatherstripping from you which is fine except the door to frame is not consistent so there is still a gap at the higher point of the frame. Can the door be adjusted? There looks like some Allen head screws on the top hinge. How do I seal the lock area? It cannot accept w ... (cont.)

This is a sash stop on a white vinyl double hung window approximately 25 Year?s old can you tell me what part # you recommend

It is grey color and used in single pane glass aluminum windows. Thanks Matt

I cannot find a door roller I need it has inch and half wheel quarter inch wide. The casing is 2 5/8? length and 1 5/16? from top to bottom and 1/2? wide.new discussion

The picture is the left side, we need the right side crank. The window is in a closed position and won't open. Can you identify what we need, found a tag that says Traco on the lock. It's cold out and they don't want the window open, so I can't remove it yet. So, if you can't identify I'll ha ... (cont.)

Hello, I am trying to find replacement parts for our broken Window Tilt Latch, the thickness of window is 1 inch to 1 1/8 inch . I apprecite your help in finding the replacement part. Thanks Srini

I'm looking for a replacement Handle for my daughters screen door and I hope you can help me.... Attached are photos of the current handle with the sizes. As you'll see in, the inside of the door has 2 separate pcs (you can see where each plate was by the marks on the door) and the outside pla ... (cont.)

I just tried reordering Corner Latch, RH 91-032 and Corner Latch, LH 91-031 and I am unable to order them. Your system can not seem to find the part. Have they been discontinued? If so, is there a replacement part for this that will still fit my storm windows? Thanks! Greg

I am needing these replacement parts. Is this enough information to be able to determine what parts that are need? I have a customer needing a coil spring (5232208) that is 3/8" wide. One for a 4 lb x 35" window. And one for a 5lb x 35" window.

upper sash will not stay up when the lower sash is raised. need to identify and check availability of the part that retracts the pivot shoe to hold window in place

Nami window saftey clip need one for right side.

Window is a Lawson, non-tilt. the shown part dimensions match up to Product No. 18-044. Thank you for your help.

I am replacing a 23" balance X 1/2" The stamp is (22 4 DS CALDWELL) wHAT IS THE PROPER WEIGHT FOR MY ORDER? Pete

Hello, I couldn?t figure out what parts numbers I need. Please see my attached pictures. Length-28.5? Thank you, Michael

Single hung vinyl window. This is the snap in glazing bead. There are no other identifying marks on the windows.

Hello! I have ten of these windows that are showing their age. I've looked everywhere for any type of markings and I can't find any. I saw a video where a guy replaced similar windows on his Airstream and said the model number is usually on the lower left exterior, but mine has nothing. I need ... (cont.)

I

Needing parts for Jordan windows. Marking on channel balance is 1610. Length is 17 in.

Hi I'm trying to figure out the weight on a balance , channel reads 34 9 HW CMC 11 . it is 1/2" x 35" long and it has series 385 shoe and top. I just don't know the weight of the sash . can you help me please. thank you Travis