Viewing all customer Discussions for:

Door & Window

I'm trying to find compatible vinyl glazing bead for my double hung wood windows. My home was built in 1999 and I believe the windows are by Marvin WIndows

Could you tell me the part # and price for the handle insert on the right. Thanks DR05-1510

Where can I find parts for my window? My keeper broke for the sliding window lock.

These are my photos comparing my balance, EE 5 23 568, and the one you suggested, 24-531. It clearly is an 1/8 of an inch too wide for my balance cavity. I had asked (with a picture) for a replacement part suggestion for an Andersen sash balance with part # EE 5 23 568. You suggested Swisco's 24 ... (cont.)

Photo attached , looking to replace the handle on my Cole Sewell Full view storm door. any suggestions? Sam

Hello, I'm searching for replacement door hardware for Cole Sewell door Registration Number 08199790030 45. Appreciate any recommendations. Cheers, John

Replacement

I have subject combo storm/screen door and sweep has gone missing. Registration number for door is 080400948640092. Measurement is 31 5/8 in x 1 3/4 in (gap is 1 1/2) x 11/16 in thick. Looks like the only one that might work is 40-003, the simplest. What do you think?

I have a customer that has Florida Extruders international patio doors, they would like to have the latches and pulls replaced. Where can I find the parts?

I need some replacement window for a window that a renter removed the stop. The window is 4 ft x 4 ft . I don't know the age or make of window there are no markings.

It attaches to window to help it go up easy and stay

I need to replace several of these latches. The screw holes are 2 1/2" on center. There are no markings on the awning window or latch.

Hi, I've ordered several spiral balances from you for my non-tilt aluminum windows. Changed both side balances on one window. It worked great. However, Several of my windows' balance shoes looked different (Photo is attached). Need your help to identify the part and tips for how to change the balanc ... (cont.)

Please see attached pictures. Pella windows were manufactured in 1974 per numbers found on sill, 704CC. Three of the four crank handles no longer work; however, one of the original cranks (stamped #4 on top, X-429 on bottom)fits and works flawlessly over the shaft/spline. Pella sent me two different ... (cont.)

2130 w is the stamp code on the channel please point me to the correct product thank you

I have a Milgard window with bad plastic pulleys, that pinch the cords in both of the 29" channel balance springs. I have ID'd the top and bottom plastic fittings on the balances from your photos, but I need assistance to determine the proper weight selection. Should I weigh the moveable single-hu ... (cont.)

Hi i am looking to get some of the white parts shown in the photo. the vinyl windows were installed in about 2000 and the white parts shown in the center of the photo hold the locking track in place. there is a lever mechanism (hurd type?) that shifts the whole metal portion held in place by the whi ... (cont.)

Hi, I need one possibly two balances including springs. I have enclosed two pictures of the balance installed and not installed. Let me know if you have this. This is what is inscribed on the balance - 2100 BSI KL. Also, what would the cost be for one plus shipping and two plus shipping. Th ... (cont.)

need to see how to twist boot to get it to move up.... also need to remount two in a window, need metal balance for one window, grey roller is broken at top, string is loose...

My internal latch mechanism is broke. Need replacement or whole lock , handle and all replaced Thank you for any suggestions as where I may find