Discussions for Door & Window : SWISCO.com

Balance identifier

I have a 22 inch long half inch wide balance. Bottom plastic piece broke. I can't locate any markings on it. Maybe S380 or S385?

+9

Coil balance

Coil balance was 4 1/8 long by 1/2 to 5/8 thick

Broken assembly part.

Hello - trying to identify window part. Broken u shaped piece in the bottom of the right side track. Looks like a circular piece that fits inside it is missing. Found the name Guardian on the glass (see pic). Home was built about 1996 or later. Can you help identify?

+2

Glazing Bead 7/8" wide white

Looking for this glazing bead for a patio door glass

Cranking mechanism

We need to replace this on 3 windows

84-096 Screen door roller but with a solid back corner

I see the replacement roller on your site but mine has a pin and I don't see one on your pic. is there one with a pin or should it still work.

Glide and post

Can you help identify the post and glide? See photos glide 265D stamped. ThanksGreg

Broken corner key

This is a corner key of a aluminum frame storm window. The slide bolt passes through it. I can't find any marking on it.

Missing part/bottom of window /Crystal Brand

Need to find replacement part for bottom of Crystal window

Simonton patio door track broken

Hi I am looking to replace the door track and wheels for my Simonton patio door. The track is coming off from its place and also the wheels are not gliding over the track.

Spiral balance

Looking for parts for spiral balance system need spiral balance retractors and the lower pivot guides for republic widows were made in 2000

part number please

I need to replace a few of these.What part number is it?

+2

Pella Window Parts

Looking for these 27"channel balance amd tilt latch pairs. Did not locate in your catalogue

+2

Need replacement parts

I have tools to replace parts for Harvey windows.

+1

Sash balance 1980s

Need help identifying the part number on these sash balances

window ballast

THe part number is located on the photo with the white paper under it. You have to blow it up to see it. I see the stamp Andersen Corp on the bottom right and below it, I see this "C9 6#23 1-85 I need two of these. I may need more. I am assuming they are the same in my other wondow, that is the ... (cont.)

+7

Window push pull opener

Allows window to open to clean outside

Red tip spiral balance holder broken

Need two new spiral balance holders 570G is on the part. Windows single hung flip open purchased 2005 at home depot(we think).

Milgard casement window crank assembly

Window crank handle pin sheared off from over turning it

Sliding door handle

I'm trying to find a replacement handle for my sliding door. I haven't been able to identify the door manufacturer...but I think it might be an Anderson. The handle has mounting holes measuring 5-1/2in on center. I haven't found anything in my area, so I want to make sure I have the correct hardware ... (cont.)

Viewing all customer Discussions for: Door & Window

Viewing all customer Discussions for:
Door & Window