Viewing all customer Discussions for:

Door & Window

However I have 4 windows all the same. I took apart two window's, one had 2630 and the other 2640 . I also do not inderstand the lenght. According to some vedios the lenght of the balncer should be below the top enjection clip. These are 3" above the clip The lenght of the metal is 27? They seem to ... (cont.)

Picture 1 and 2 is a handle for a screen sliding screen door each picture shows each side of the handle. picture 3 is the rollers under the same sliding screen. when I use the google and took a picture identifies this as a Swisco item but can't find it on your site. this is from apartments tha ... (cont.)

seeking this part

Need 4 replacement springs

Good afternoon, I am looking for replacement glazing similar to my original in the photos. I was looking at the 55-106 but am concerned about that outer spline.

Looking to replace this hardware.

Hello, this is a silver line connector, do you have this in stock? Thank you. The part # is 6845593.

This is from an Anderson casement window bottom corner. TYVM

Looking to identify 1) the latches on my lower window. Need 2 of both left and right. 2) the upper pivot lock show, along with any advice on how to replace the metal part. Need 8 of these.

I have 3 window cranks that broke and need replacement. Can you identify the right parts for replacement so I can place an order. Let me know if you need additional pictures Thank You

Part of the handle that attaches to the window frame has broken

Hello there! I'm needing to get a quote and confirm styles for balance replacements. Needs: 14 total - 32-4 .measuring at 32 7/8 2 total- 26-3 measuring at 26 7/8 4 total 14-3 measuring at 14 3/16 I'll also need some frame clip replacements, 4 total for the window frames. What else can I supply ... (cont.)

I need right and left channel tracks for a jeld wen tilting window with the 26C stamp

Pivot lock shoe replacement 1 1/4W x 2L x 13/32T

Looking for replacement of metal latch that needs to be replaced

I need the size from top to bottom 4 & 1/2 in., or between the center 2 screws 3 & 1/2 in. The 82-229 just to tall 5 & 3/4, I must have this style able to push in the hole. Thanks.

I'm sorry these pictures aren't the best. I also do not have any type of name or number for the parts either. I recently purchased the house i live in this past October and have no paper work of any kind for our windows and such.

Need 2 total

Hello, I am looking for a replacement window crank assembly for a bay style casement window. The pictures are from the Left Window. The linkage long arm is stamped "L" and "31538A" the long arm measures 8-3/4" the mounting hole centers are 3-7/8"

Looks similar to a few you have listed. Shoe 1/2 " deep, approximately 3/4 wide.