Viewing all customer Discussions for:

Door & Window

Does your product 55-151 come in Bronze? I would need 50 pieces.

No visible markings, measure 3 1/8" long, 11/16 depth ( where rollers are in) , 1 1/2" height. Rollers are 1 1/2". No company name on door. I'm thinking these are your 81-153 I saw initially on your site, but can't find it again. Looks just like it

I want find out the part # for my Patio Sliding Glass Door Roller 81-056 I am enclosing the pictures Pradeep

I am looking to replace the 1/4 dia plunger pin in my screen , the sash is 1 inch wide. will your #70-008 plunger pin work ? I'm concerned the 1.5 inch length will be too short . the existing pin measures 1.75 length OAL with the plastic knlb in place . Thanks Don

The shoe from this guide is .693 X .606 X .093. the square locating pad is .260 X.272 X .084 the retaining post is .152 d x .37 high there is a "250-106" and a "2" marking the door has a channel about a quarter inch wide It might be a Jim Walters door. it takes your part 84-026 corner roller ... (cont.)

Hello Representative, I am hoping you can help me with a replacement handle for my mother

Question: I have a Pella Wood Sliding door purchased in 1995 I would like to replace the rollers. PART Number on Pella Receipt is: 1F/DFXO26 1F/DF012 Can you recommend a roller replacement part? also Do you have a video or instructions on how to replace? Thanks Joe

Can you identify this pivot shoe?

These are the spring/tension clips for the Milestone 4000 series vinyl insul impact sh's . I am looking for these and all hardware associated with this screen. Please help if you can.

i need help identifying and ordering this part. 1/2" width 22" long from tip to tip

I need replacement balance please

Length of the metal bar is 27"

Please take a look at my Stepped Sash Guide. Do you sell this? I could find a match. Thanks.

We bought a apartment complex in 2006 and have been trying to find parts for our windows and this is a internal latch 2 and half inches long and 7/16 wide. We dont have any ideal what kind of window these are. The top of the window is fixed the bottom goes up and down and can tilt in. I found the pi ... (cont.)

I need to get 2 replacement rollers matching the attached pictures. It is 1 7/16" tall x 2 1/4" long and 3/4" wide at the little bumps on the side of the unit. The roller is 1 1/4" outside diameter. On the side it says "Product of Del Mar Eng. Co Long Beach CAL". I don't see any model number. ... (cont.)

Hello - Sending three photos of part required for sliding glass door. The length of the wooden handle is 11". The holes that affix the wooden handle to the metal bracket are 6" from center. The holes that affix the handle to the holes in the door are 5" apart. Markings on the locking mec ... (cont.)

I'm back, need Anderson counter balance Pull top of window off Part # is 11600-17 T3L12 / 1827 987 Window etched with CIG-2 4-87

I am looking for this particular glazing bead for a job for we are trying to quote. It is from an Arrow window. They are approx. 17 years.

We cannot get replacement parts for a Pella glass door slider. We need the vinyl strip that are on the inside and outside of the door where the handles are. We also need the inside handle, which apparently has been broken off over the years. The vinyl strips measure 79" top to bottom. I h ... (cont.)

Hi, There are no identifying numbers or company name. Help. I need four. This is for two very heavy 1965 apartment windows that slide to open.