Viewing all customer Discussions for:

Door & Window

Thanks, take a look a picture, It a Tilt window latch.

I need a 4" extension for a gray aluminum window crank. The only identifier is a number (45054) underneath in the recessed of the handle. The 39-422 looks ideal but is only 2". Do you have this in 4"?Many thanksPhilip

Hi, I need a replacement part for the patio door. I took some pics per attached. Can you help me identify what part I need and if you carry it and how much. Thank you Leonard

I just bought an old house, circa 1950's, that has springs(no tubes) for balances. how do I decide what balance I need to replace them. The top has a bracket where a screw goes through a spiral of the spring that has been turned up. the bottom just hooks over the edge of the lower window mullen (spe ... (cont.)

I believe this is a General Aluminum glazing bead, came off of windows in a hotel. We are replacing several windows and need replacement glazing bead like the one in the pics. The width at the fold is 1/8". Please help! Thanks!

I have a Gorell Doorwall model 6002. I need rollers for this door and was wondering if you have them and how much are they?

I think I have MI windows but not sure. Trying to find the part that holds the window up that the pivots go into. Not sure if it is a whole unit or not.

My coil sits in side a small plastic square that has a hole in the center to screw in the channel of the sash. Do you anything like this

I have a kawneer double door bronze in color I'm looking for the pivot piece at the top could you please let me know if you have this and how much thank you

I need to replace the entire inside mechanism for my sliding glass door pulls I have both the inside and outside parts I have the following from Miami, FL OUTSIDE DNS Industries 13/23 OUTSIDE PULL -1400 SERIES INSIDE DNS INDUSTRIES 12 INSIDE PULL -1400 SERIES I NEED THEM INSIDE LOCK PARTM ... (cont.)

Dear sir :Can you quote me a price for 4 wheel rollers if you can find a similar model could not see a part number on any of them as they are in pretty bad shape.Can you include your shipping charges to 00961 Puerto Rico?we use USPS service.

Require 2 new roller assemblies. What do you recommend I replace them with?

Length top flat ( sash side) to tip of rounded end is 2 5/8". Width of top side is 1/2". Depth of latch( fits in window groove) is5/16"

I bought replacement rollers from you in 2008. Can you please find that order and let me know which rollers were on it. Thanks, Jay

Can you please determine the type of latch I will need? The stickers are not legible from the window company. This is for a tilt window. And I will need a dozen right and left. Deron

Need part TAIWAN 2260 us PATENT 5125703 D340398 Do you have this part? Cost for part? Cost for shipping? Have handyman who will install. Thank you! Karoline

These are 2 balances which I took off a simonton window,I'm not too familiar with window parts. Is this something that you may stock.I'm not sure of the sashes weight I hope you can help.

Dear Sir/Madam, I would like to replace Latch Assembly or just C-shape component (overall dimensions: .7" x 1.75", thickness .25", distance between holes 1.38") in my old patio sliding door. The pictures of the Latch Assembly, C-shape component and Latch component are attached. There is a te ... (cont.)

Hello. Can you please take a look at these latches and see if you have something comparable? Thank you, Scott

The channel is 18" long and 1/2" diam. The channel is stamped 1720