Viewing all customer Discussions for:

Door & Window

I have 13 photos for you to view. I believe I have Identified your parts for all but the face guide from your website but would like confirmation from an expert 1st. My photos include channel balance code, entire channel balance, balance shoe, balance top, Kinco 5/8's top sash guide and face guide. ... (cont.)

The spring on one side broke and as a result I need to replace both window balances. My house is 19 years old and these are the original windows. There was a plastic covering over the balance but it became brittle and disintegrated. I have attached photos of the tip (blue), total length, width op ... (cont.)

I need on of these ASAP

Hello, The casement operator I am looking for is on a window purchased in February of 1999 in the Sacramento, California area. The paperwork shows it as a brand called Insulate/Vinyltek Series 200/700. It is a vinyl window. I contacted Vinyltek (located in Canada) and they said that this was n ... (cont.)

Do have these or know where we can obtain them and who manufactured it we need 2 Thanks

Please approve the details for purchase 24 nos. of wheel assemblies Thanks Sanjeev

model 450 alum window balance with pivot bar

I need to replace the sweep lock for a Champion window. The attached pictures tell most of the story. The screw holes are 2-1/4" apart. The height of the portion that goes into the upper window measures 3/16" at its highest point, but frankly it is hard to get it to go all the way into the window. ... (cont.)

We are doing a project for the Minnesota Historical Society and they want to replace all of the spiral spring balencers in a 1940's +/- cabin. Attached photo's show the originals no markings that we could find. They do not tilt and they measure 5/8" diameter. We have 24-27" that pair with 24-25" ... (cont.)

Please identify replacement balancer: Metal part: 36" long depth of bottom part: 1 3/32 Window weight: 25# Stamp: 35 3 CR CALDWELL

I have 3 windows in my main front room. All of the metal channel balances, window clips and rope clips have broken. I need to replace everything. My windows are 41.5" wide and 28.5" in height. The stamp on each channel balance is "25 DS 35". After the 35, there is a vertical "B.S.I." stamp, fol ... (cont.)

Can you identify for me so I can place an order? This is from a double hung sash. Thanks.

replacement lockset Will forward the handle set next DNS MIAMI FL

I need to replace two old storm door handles, and haven't found anything that will cover the existing hole (about 1" x 1 1/4") in the door. It's a simple push pull latch, I think.

Hi, please see attached pics. The spacing is 4 15/16, with a clamp style lock. Is 82-009A the correct replacement door handle? Can I purchase just the guts, or do I need to replace with entire handle set? If just the guts, which part(s) do I order?

please help me identify a plastic piece that helps thread a screw into the upper sides of a vinyl replacement window in the interior casing near the spiral balance. Please see images...

House is in south Texas, built early 60's. Windows are aluminum, single-hung non-removable sash.

I have the drawer guide with U.S PAT Re 32.134 W1 and Drawer Socket U.S PAT Re 32.134 W5 I need 11 of each. Let me know if you have a replacement for the parts.

broken. :(

The sash is large measuring 35" wide by 31" high by 7/16" deep. Manufacturers label says Florida Extruded Products Inc. Model name is Milestone Single hung Series 1000. Needed parts are left and right balance assemblies. They are spring/block and tackle type. The spring and block and tackle a ... (cont.)