Viewing all customer Discussions for:

Door & Window

1/2 inch channel is 16-7/8inch long Window was made by Jeld-Wen in 2022 Channel is stamped 16 4 CJ. AZ Please send us 2 balances

I need to get several replacements of this right and left sides

Can't find any markings. GC says it's a shwinco door. One set is completely wasted. Would like to replace both sets for this door

I have nami 100/200 windows and several balance rods need to be replaced . I see the replacement part is no longer made . I am attaching pictures that will hopefully help find a replacement .thank you Sandra

A latch for tilt and turn windows used in my house that are getting worn

Looking for a set of handles to go with this sliding patio door lock. The one they have now doesn't have a key cylinder. They would like a handle that has a key cylinder on the outside.

26-243 may work but more info needed. In the picture I am sending the 3/8 horizontal dimension(at top) the thin part would be the top which is 11/16. I need the dimension below that which is the body. That and the length are more critical than any other dimension as the body fits into slot in w ... (cont.)

I'm looking to find a piece that can match this roller for aluminum patio door. Thx

The left door is hinged on the left and opens outward, while the right side is hinged on the right and opens inward. I do not see any markings on either.

I have no idea the manufacturer I know it's an aluminum frame sliding glass door

Hello, This is a single pain glass aluminum framed sliding door from a Condo building built in the 1970's.

Hi! I’m trying to identify what this part name would be? It’s broken and I need it to be able to open and close the window properly. It is about 45 inches tall. Thank you,

I have no idea what brand of window or crank mechanism this is, but I wanted to add folding handles to them. Can you tell me which ones would fit? The splined shaft appears to be 11/32" and has 12 teeth. Thanks

Hi, I need to replace one of the crank handles. Attached photos are of another handle on an existing window and the window with the missing crank. Thank you

Looking to replace my patio door handle. I'm experiencing difficulty matching the color.

May you please help me find the best replacement for this Milgard window crank and housing? The window will crank open, but the crank just spins when I try to crank it closed.

Do you have these Ply-gem

It's a Alenco Window. I need 2 channel balance hardware. I believe it's 1" deep and the metal part is 28". 30" bottom shash window part. Would I need a 28" 351 Series? 30" bottom shash window part . Thanks!

Looking for the whole operator mechanism, looking for what model number it is

Length of the metal channel: 20-5/8" Stamp: 20 4, then a sideways BSI (very light), then a small RF. (See pictures) Total length is just under 22" (see pictures) 2 balances needed