Viewing all customer Discussions for:

Door & Window

There's no identification on this part. Thanks Bob

I need sash balances and shoes. The old oles are stamped 34B. Can you please help me locate the correct replacements.

37 inches long , do not need top or bottom attachments. the bottom just had a flat piece of metal that went under the window.

Seven windows to replace snap in glazing

Looking for 28 " and 38" Channel balancer with hook at bottom end , and nothing at top end

As you can see in the photos there are plastic pins attached to the sides. And hooks that hook onto the pins and prevent the window from opening after it is shut. I don't know the technical name for either of these parts or where to find them. Any help would be appreciated!

I have Gorell 5300 series double hung windows that I need to replace the springs and pivot shoes, will this spreader work or do I need to cut the frame? I would like to remove one so I can see if there are any part numbers on the springs and shoes to make sure I order the correct items. Thank you ... (cont.)

The previous owner of house didn't have this installed in the window and it was broken. In need of this part. Stamped 26 C

I have a Sears storm door with an Emtek 322 latch assembly. I was looking at your part 40-049 and the discussions about it. All of the dimensions look to be the same on the edge and the inside but the outside plate has an overall height of 8 7/16" and mounting hole center of 7 15/16". I've att ... (cont.)

it's old 2860 Patriot window with spiral balance. can you identify the part? I need to replace the balance and sash lock.

Trying to locate these parts . Notsure the description of them.

Hi, I have several Pella casement windows from about 1983. They have lock handles like the one in the photo. This one is OK, but about two feet up, the lock/latch piece, which does not have a handle, is broken. Do you have a replacement?

This house is old and has 14 windows which have parts like above used to open and close part of the window. Want to replace thse

I cannot find any part numbers or the name of the window. Help. I need to get a quote on the replacement cost so I can then order from you.

1st pic is the bottom of spring assist, does not appear to be hooked properly. Is there something missing? pic 2 is the top of sash and top of assist pic 3 and 4 is glass stop in need of replacment

Sears windows that where put in 2008 - 2010?? Part # 326 for latch??ThanksRobert

I have Pennco windows (not sure which model). I removed the pivot lock shoe and it looks exactly like the 15-208. It is 1 & 1/4" x 1& 1/4" but it is only 17/32' thick. I was wondering if the 9/16" is the actual thickness or a nominal thickness or does that include the metal piece in the midd ... (cont.)

I replaced a glass panel in my custom sliding door. Door size 96H x 72W. Glazing size 31 3/8" x 891/2" x 3/4" (white) Pic 5104 shows the existing glazing for the sliding door Pic 5015 shows the glass door without the glazing. Unfortunately, I do not have a pic of the glazing which was removed. ... (cont.)

Aloha,See attached photos. I need to replace a broken window balance and need help ordering the right one.Mahalo,Charlie

Looking to replace all existing hinges on kitchen cabinets. Only part number I can find is pat 3.391.420.US. I measured the overlay of the door to the cabinet face at 1/4". Hoping to find a hinge that will match up with all existing holes. I have 19 doors to replace.