Viewing all customer Discussions for:

Door & Window

Hello ~ I have a broken awning window for which I hope you can provide replacement parts. It is a WeatherShield 8204 Aluminum Clad Awning, installed in 2008. The window was yanked upward when partway open, twisting the operator arms and pulling the guide bar off the awning's interior wood frame. ... (cont.)

Hi, I need this part. Can you assist

Hello, the 9/16" channel balance I'm looking for was stamped 2840P. I'd appreciate some help finding it, thank you! It's a non tilt window

Good Morning, I hope all is well. I have a double hung window, where the top sash will not stay up and closed. We measured the spring balances and ordered the same ones, 31" x 3/8", but after installation, the window would not remain up. Any insight would be appreciated. Thank You, Kevin ... (cont.)

Please let me know if you have this bar ?whats the item number ?whts the cost per piece ?thanksDavid

These parts have a number but hard to see - think 4610100 The window is manufactured by Atrium Can I still get this part

Tilt bar with plastic wheel about 10inches long

Hi, I need to replace this pivot shoe (15-229) on my window left side, can you please advice which one is needed for the right side? TIA

Bought this house recently with no indication of who made the windows. need tilt lever replacements. I measure 2 and 9/16 long by 11/16 wide by 7/16 deep, rounded backside. please help!

Channel balance for single, non-tilt window. It has the follow printed on it 36 5 AV CMC 2. I also have another one that is identical except it has 36 4 AV CMC 2 printed on it. I would like to replace these.Please help me identify. Thank you!

#782

I'm sure this is a 15-177, the problem I'm having is the coil. There's an "F" stamped on the outside, instead of a number.

The only marking or indicator I can find is 33C stamped on the channel balance. Should be able to see it in the picture. The metal channel measures 34" long. Not sure how much the sash weighs at this point.

Please advise me as to how to obtain these parts for glass Anderson sliding door. It's probably from the 80's and it's a thumb larch handle. Thank you.

32 5 LO Caldwell Channel Balance

Looking for a window handle with 45001. Also has some patent numbers as well. Just like the pics I found.

Window on left side does not stay up. Measurement from end to end is 29" over all and 28" metal to metal. The fin on bottom measures 1.3

Hello, I have a window balance with the following stamped on it. "25 5 BSI PJ" The length of the metal channel is 25.75" The window weighs approximately 25 lbs. Can you let me know what I need to buy to replace this? Thanks, Brian

3 Handles for VNL-M-46 Windows from ViWinTech Windows & Doors

Found no part numbers or manufacturer.