Viewing all customer Discussions for:

Closet

The bottom pin slides into the plastic housing. The doors are mirror bi-folds.

I HAVE A CUSTOMER LOOKING FOR A REPLACEMENT WHEEL OR HING I AM ATTACHING PICTURES OF WHAT IT IS I NEED REPLACED. ONE OF THE WHEELS HAS A FLAT SPOT AND DOOR WILL NOT ROLL ANYMORE.GRANT ROCKET 2 WHEELS 1-3/8 FRONT 3/4 REAR. IF I CAN SEND A PICTURE PLEASE LET ME KNOW.

Hello I need this wheels fir my mirror closet, inside the frame it says: Stanley 4011 U.S. Pat 3.058.173 or 3.056.173 Pat CAN.1963 Please help me out Thank you

I need to replace the roller for my mirror rolling door. Picture is attached.

overhead track/channel, 105.5 inches long, one piece and required hardware for the 2 bifold doorsI need to buy the track and all hardware need. The track is 1-1/8 inches wide OD.thank you

I can't find where I can buy replacement parts for this Stanley mirror sliding door thing. Here's a front and back picture to help in identifying it. Thanks for the information.

I am looking for the Stanley top track for a mirror closet. See attached photo.

I have a Homedecor Innovations Bi-Fold Mirror Door that is not operating correctly. It seems that the bottom pins do no raise the door high enough for the top pins to stay in track. Also, the to sliding pin is either broken or missing. Is there a schematic to see what is missing or what I need. Ther ... (cont.)

Top of mirrored closet door, no part number that I can see

Roller23-028 9/16 measurement is too deep doors wont bypass.

Closet doors are about 35 years old and the only information on the wheels says: Production Enterprises Miami, Florida

what is the width measurement on this track: 47" BOTTOM CONCAVE ROLLER TRACK Product Code: 23-270

This is at the bottom of the door. It snaps in to metal and rides in door floor mount

Hello I am looking to try to find the pins shown in the picture. I measured the nylon as best I can and it appears to be 3/8". The overall Pin length is over 5.5". The pin is approx. 3/8" in dia but might be slightly smaller. I am wondering if you could provide input if 21-065 might work or w ... (cont.)

I am a home owner and do not know how long thees tracks have been in my house but they are completely rusted and requires replacement.I am looking for replacement wheels as well as the tracks. I have attached photos for your ref but appx dimensions are length 4', Track width 4" and width of each ch ... (cont.)

Nylon/plastic roller 1.25" dia. 0.25" wide Length of metal piece holding the roller ~2.5" Distance between the center of the holes that clip on the door and the center of the roller ~1.5" Width of spring steel a little over 1/8" Length of spring steel ~2.25" If a drop in replacement doesn't exist, c ... (cont.)

I am trying to locate the pin set top and bottom for the 70 steel door. The door is 17.75 per side. 35.5 overall. The pins on one side screw into the door. The top side appears to be a spring loaded and around 6 inches in length. I have the bottom two and one top. Here are some images of the top. ... (cont.)

I ordered door hanger 23-047 and the part was not the exact part I wanted. The top part is a little different. Can I get the same part that is in the picture. Thanks John

I would like to get a replacement for that missing parts (rollers wheel only). I'm not sure about the name of the part. Please let me know what is the cost of the part and if it is available.

I'm looking for a replacement bottom roller for my Stanley mirror door. I'm not sure which part would do the job.