Viewing all customer Discussions for:

Drawer & Cabinet

The number on the socket is 6000100200 it measures 3" long x 1 1/4 " wide and the opening is 1". Do you carry this item or a comparable replacement? Thank you

Do you have this part for a Vaughn Basset dresser? It is 1 1/8" diameter and 3/16" thick.

In reference to my order listed above, it appears that I ordered the incorrect socket sizes. The sizes required are s few inches bigger than what I ordered ordered. Please see the attached photos. Providing measurements has been somewhat of a challenged for me as I've been unable to measure to wh ... (cont.)

The slide I need to replace is from a High Boy drawer and the plastic that holds it to the track in broken. It is a standard size and I've seen them many places. All of the drawers have this type of slide at back to hold to a center wood track. Also want to replace several worn side glides on low ... (cont.)

if you can tell by the pictures the slide pocket is mounted to the rear and the drawer slide has a "L" shape at the rear that fits into the slide pocket

what is the width of the wheel - i need 3/4 inch diameter and 1/8th of an inch wide to fit in the track that I currently have. thank you for your repsonse.

steel wheel 1 inch part 3 inches long 1 inch high name on part Garcy

My broken socket part would be a match for your Product Code: 32-025 except mine is 4-3/4 in in length (32-025 is 3-15/16 in). I guess its a factor of the drawer depth - my cabinet drawer opening depth is 4-1/2 in. Do you something that would accommodate? FYI - I found a replacement par ... (cont.)

Could you point me to the proper replacement part for my decorite drawer slide socket? Mounted it's 2.5 inches high and 3.5 inches long. The slide is 1 inch. See photo. Thank you!

WHAT SIZE HOLE IS REQUIRED TO ACCEPT THIS ROLLER?

We recently had two rear sockets break. I have searched everywhere and cannot identify these parts. Any help is greatly appreciated.

Need for drawers in kitchen

Bracket I am attaching a photo of a bracket that goes in the back of a drawer on one slide under the drawer, the cupboards were made in the 1984in sioux falls south dakota, I am wondering if you have any that are like this, mine is broke

This is a photo of a rear drawer guide I need 12 of them the best I can come up with is 2 1/2 wide 2 3/8 rail size 1/4 rail opening it resembles part 32-031 can you help Me with this

I have been looking for a replacement part for my kitchen drawer. The plastic socket is 3 3/4 inches long and the local hardware stores only carry a part that is shorter than this. I am hoping that you can help me find the correct part. Thank you, Sue

20" Drawer Slide.

I am trying to replace 1 1/4" rollers that have a metal axle (no ball bearings) that have worn out do to repeated use with heavy loads

Have 1 inch wood rails in good shape. 16" length. Center mount . Could use front &. Rear SWISCO type brackets or 16" length pieces. That would attach to bottom of each drawer . Can you help me out.?

I need to match the slider that I have pictured above. There is one of these parts in each of the four corners of each of the drawers of a dresser that I purchased from Crate and Barrel about 10 years ago. They were missing when I purchased the piece. I need about 10 of the sliders. I hope yo ... (cont.)

the wheel is a rivet style. Measures 7/16 diameter, 1/4" thick flat profile wheel, 3/16 out from side of the drawer