Viewing all customer Discussions for:

Lavatory

I am going to purchase this item to replace a snap on sweep that is not tall enough to fill the gap between the bottom of my frameless shower door and the curb (manufacturer set included a 3/8inch sweep but the door and hinges are drilled for a 1" gap?). Anyhow, I'm wondering if you would recomm ... (cont.)

Is it possible to purchase just the rubber tips for the coat hook 10-525? Looking for 100 or more.

Does this knob assembly come with locking washers to hold the two pieces in place?

I am trying to replace the knob assembly your part # 10-556 on a bathroom door. Do you have some directions on how to install the replacement knob. Looking at the part it appears that the knob presses into the door, but I am not exactly sure how to go about this process.

I have Stanley Mirrored Sliding Closet Doors. I need handles for 2 of them. My other Stanley doors have a handle that looks like your #:10-005 clear flat adhesive handle, but they are glass. Is this item glass?

What is the thickness of door that a "10-557" will fit? My doors are about and inch thick

I need to replace my bottom rollers on my sliding bathroom mirror. The chanel on the mirror will only accept a roller that is 7/16" wide. Do you carry them in that size?

We need to replace rollers on 5 slider windows that measure 3 x 5-1/2 ft. high. Do you recommend the Heavy Duty roller (10-118) or the 87-006A (which is what we appear to have now)? Also, any installation hints would be appreciated. The windows enclose a 2 story sunspace so access to the gl ... (cont.)

this part of yours states the wheel is 1 inch . the ones i need to replace on my tub master units are 15/16 .will your parts work?

Your catalog shows an offset handle towel bar holder for a sliding shower door. This item carries a part number elsewhere of FSDTB 9905 CH. That's including the bar and all screws, etc. Your catalog shows a price of almost $15 for each handle only in Chrome. You show it with 2 1/4" spacing between ... (cont.)

What is the difference besides price? Looks to be interchangeble, will the 10-118 hold up better and last longer?

If you can tell me how to remove a latch similar to your item 10-557, I'll consider buying a couple of them for now and later (which always arrives sooner than expected). Thanks, Ron

Have an original tub master shower door purchased in 2000 the rollers and snaps connecting them are worn and the door keeps coming out of the roller. Do you have those replaceable parts? Attach is a photo showing parts

The 10-118 looks like the replacement roller that I need size-wise, except that mine has two holes on the top located on the ends. Should this matter? Thanks. Tom

Re: Product Code- 10-129 My house was built in 1977 and has the original vintage looking swing-out frosted glass shower stall door. This morning, the aluminum handles fell off. They are 6" long, however the pre-drilled holes are 3 1/2" apart on the door. I'm looking for information about how th ... (cont.)

I am looking for this part, its is the bumper for a inswinging parallel to the wall commercial restroom door. This one is intact and I have a broken one in the other restroom. can you help? Jamie

Tub Master part 19. B roller assembly and bracket. The rollers are on the top of the Tub Master shower doors.

What about providing fasteners that match?

I need 2 complete sets of this hardware and one "receiving end" only - not the slide latch part. The dimensions are 4 1/4 hight, 1" profile, and the slide part is 3/4 ". A photo is attached. Do you have these? Thank you!

I need some replacement hardware for a towel bar. I am sure that there are more than one kind. How can I tell what hardware I need? Where can I get replacement hardware? Lisa