Viewing all customer Discussions for:

Other

Good morning. I need to replace all the hardware for a window. The base wood rotted and some of the hardware is now missing. The crank also broke. I'm sending photos of the broken crank and the set up from the opposite windows. Numbers appear to be #31538, #6295P, and #29810 or #20810. Thank you! ... (cont.)

broken cast part to raise and lower window

This is the clip that sits in the channel where the upper 1/2 of a double hung window connects. I have several windows where the plastic has deteriorated and broken

Crank and handle with broken part in the crank. 1LH on the bottom.of the plastic cover of the handle

What information do you need in order to direct me to the correct replacement part that doesn't contain any plastic??

Hi, we have a window crank arm that is not working (probably was opened too far) and needs replacing. I am attaching a photo. It looks to be a "split arm" and I only see 9 of these on your site - none of the ones on your site have the screws lined up the same way, so I am wondering if this is some ... (cont.)

I'm looking to replace the balances on an original window in our 1999-built home. I believe it is a non-tilt sash window (vertical slide) and appears to have spiral balances. Any help/advice you could offer would be most welcome. Thanks! - Jeff

I went ahead and took down the window. Below are the approximate specs that I am getting. Thanks, 1 1/4" x 1 9/16" x 1/2" Anything that size or close?

There is no brand on these windows. This is the upper sash balance and pins.

I need replacement channel balances for 4 vinyl windows. They are stamped 26 5 EP Caldwell. Metal measures 27" I also need a replacement channel balances one vinyl window. It is stamped 32 6 FP Caldwell. Metal piece measures 33". See pictures.

Broken top part of the balance. Window sash top stop as shown

looking for bracket

The window sash weighs 9 - 9 1/2 lbs.

I need to replace my brush door sweep on Pella Entry door 010918P0610822361NFRCPEL-M-174

PIVOT BAR IS 2 1/2 INCHES LONG, WINDOW WEIGHT IS 3 LBS, SPRING HOUSING HAS THE LETTERS A,B,C,D,E,F ON IT. WE THOUGHT PART CODES FOR THE WINDOW IS 26-030 FOR PIVOT BAR AND 15-177 FOR THE COIL BALANCE SHOE. WE NEED HELP WITH THESE PARTS TO SEE WHAT SPRING MATCHES AND TO MAKE SURE ALL PARTS ARE CORRECT ... (cont.)

Pella sliding door seal

These plastic parts hold the window closed

Jalousie Window OperatorMeasurements:Between top and bottom holes - 5 1/4"Between bottom holes - 1 1/8"Arm length - 2 1/2"Width - 15/16"I am in need of 6 units of each of the parts listed in the Subject l

I am trying to make sure I have the correct hands and hardware to fix my windows. I have attached 3 pictures showing the setup I have. I would like to replace the crank and the casing. The handle just comes out and I am assuming its not supposed to do that. I think I may need the arm as well. My ... (cont.)

Is 39-091 or 092 the correct replacement part for crank in pictures ?