Viewing all customer Discussions for:

Other

I need to replace 8 of these window screen corners. I have not been able to find them!George

Confused. The latch turns but does not lock the door. Do you change the handle, the inside latch or the hook that it locks into. Thanks

Can't find the right HW for this casement window, in stores.

Morning!I have the windows listed in the pics and the tilt latch is missing in several locations. Need to replace and Can't find them online. Asking for some help. Also noticed your in S Jersey. Hook a brother up! Left Mullica Hill a few years ago and am now in Tampa with the military. If I ha ... (cont.)

Identify rollers

I can't seem to get anywhere with the manufacture, do you sell these parts?

Hi I need help finding parts for my windows ice it's hard to open and close. Need parts on the left and right side of windows

These are Andersen operators. The core is missing from one and I wonder whether a core can be purchased or maybe a core removed from an operator that I could purchase whole, rather than remove the entire operator from the window. I am including a pic of an identical operator with the core and hand ... (cont.)

Looking for new replacement units for customer door

I am looking for left and right, (right most important) P/N 85-1315LHW for left. Looks like out of production? Do you cross number exchange? Do not want to trim, etc.

broke retainer clip while reversing thumb latch

Hi, I'm looking for a window lock. The window is a tilt in window with a lock at the bottom of the window.

MY SLIDING DOOR DOES NOT MEET THE CLOSED DOOR FRAME CORRECTLY, WITH A SMALL GAP AT THE TOP. THERE IS NO ADJUSTMENT AT THE END OF THE DOOR OPPOSITE THE LOCKING END TO ADJUST THE ATTITUDE OF THE VERTICAL MEETING. THERE ARE TWO COVERED OPENINGS AT THE BOTTOM OF THE DOOR ON EITHER END THAT I ASSUME W ... (cont.)

Hello! I have a bunch of rusty crank operators I am hoping to replace on Pozzi windows. Please see photos attached. May I have some guidance on the correct part numbers? Thank you! -Allison. P.s., I have ordered parts from you before and been super pleased! You really solve a problem for those ... (cont.)

Looking for complete door handle assembly. Sn/ 08199790028 252

Hello, I have channel balances 29" long metal (not including plastic ends) I don't have window measurements, but I do have the screen measurements for that window: 31" tall and 49 1/2" wide. The only stamps in the channel metal that I can see are "28C USB". Please advise which channel balances ... (cont.)

Portion that slides between glass and frame is 20mm wide. Portion that covers glass is 15 mm wide. Rigid, 2mm thick. Color is putty/light tan. Need 30 feet. Thanks for your help with this!!

Hi. Ive got a single-hung non-tilt window with a bad balance. It is 23" x 3/8", red. I see you have the balance but I dont see the missing the "foot" on the bottom of the window that the spiral hooks onto. Heres a photo looking up at the bottom of the sash. I couldnt find it in your catalog. Its ab ... (cont.)

Looking to find this. Joe

THIS SEAL SLIDES ON FROM TOP GROVE GOES OVER SCREWS AND IS HELD IN WITH A ROLL PIN TO KEEP FROM SLIDING OUT OF GROVE