Viewing all customer Discussions for:

Other

I need this lock in bronze. Two left handed and two right handed along with the crank in bronze. I am changing the color of a room and need the window hardware to be dark.

I need slider handle Series 1000 ANSI amazing SGD C20 MST 10080

I need a replacement operator. The crank screw is stripped in the housing

I need to purchase the correct Simonton window coil balance assemblies for a window in our bathroom. I included the sticker in the top of the window. If you can direct me to the the proper Simonton window coil balance assemblies for me to purchase I would appreciate it. Thanks. Scott . ... (cont.)

Balance busted loose and broke through latch.

Both pivot pins in the top pane of a double hung / tilt window are bent and broken. One screw is missing also.

Hi?need a replacement for Mepla 664.265 53.20 It attaches to the cabinet on the backside of the face frame (parallel with the door when it is closed). This is a corner cabinet lazy Susan door. Photo shows me holding it in place Bc I have put some new hinges (that don't work right) on so cabinet ca ... (cont.)

This hinge is an original from cabinetry installed in 1971 house was built

I have sent 3 photos. The first two show the only part left that is intact. The "flat" plastic section goes into a slot along the outside of the lower window frame near the bottom. Then the bubble tube folds under the window. You can see the slot in the third photo. The length of the whole piece is ... (cont.)

looking for this drawer roller.

I have ordered before. The total length with out clips is 15"

Hi, Need a a set of this window latch for two windows Regards, Gerald

No markings. Would like to replace with equivalent

WE ARE NEEDING TO ORDER THESE PARTS FOR A FEW WINDOWS.THANKS, EMILEE

Cord broken. No markings other than the code in the enclosed photo. Length = 18" 14 year old.

I have to buy 2 kitchen cabinet hinges. The broken one has letters and numbers on it. "DTC 2 Z 45 degree 4c6A 4F6" Please help me to find the right hinges. Thanks.

Window lock , need 6 sets

Hi. I'm looking for 3 1/2 solid brass ball barring hinges

I managed to remove the only pivot pin that I didnt break when removing the sashes. Not sure if bottom and top sashes have the same pivot pins. I dont Dee it listed on your site.

I am looking to replace balances in two windows that are in the pictures. I never saw ones like these. I was not able to get a name, or manufacturer. looking for some help!!