Viewing all customer Discussions for:

Other

Single wheel almost an inch wide and 2 3/4 long. Aluminum frame door from probably about 1980.

I need to rebuild both crank assemblies in this WI dow

Hello, I am needing a couple of quick tilts and pivot bars for my simonton windows. They are about 10 years old. I do see "2" printed on the plastic for the quick tilts. Thanks, Casey

Part fell down into frame no names, numbers or markings any where to be found.

Made in New Zealand, appears to have markings MW on the handle. 4 15/16 center to center. Door is 1 1/2" thick Has a dual locking mechanism one goes up other goes down

I need two of this set complete.

I already tried your 32-018 Rear Drawer Slides but they are too tight for the slide, plus the spacing for the screw holes were wrong. So I'm asking the experts this time to find me the correct ones. On the originals it says Ferrari G024.

Hi, I am looking for the other side to the roller shown. THat is I need a Drawer Left assembly (DL). The one shown is Drawer Right.

missing one roller pictured. Plus the bottom metal bracket that goes into floor (and plastic insert) that separates the doors. possibly Andersen. thank you

how to find out which shoe pivot to get , what size , what should i measure ? Thanks.

Hi i am looking for the part number that would best replace this sash balance. the stamp on the inside readsD86 8#27 8 87 11600-17 looks like the other side say 1967 Canada

I'm looking for this center plastic drawer slide and the plastic slide holder at the end. I have a drawer in this kitchen that is missing these two parts and looking to find these parts or replace it with something similar. Thanks

Does the screen need to be removed to change the balance

We installed American Craftsman single-hung windows in our home in 2006. One of the balances failed. The window frame weighs 20 pounds, the part ID on the balance is 20 5 fBS1 The windows were purchased in Marathon, Florida, which has higher storm ratings due to Hurricanes. I have attached th ... (cont.)

I have original windows in my home stamped C-Wintite on the frame. I'm probably going to wrongly assume the sliding glass door is the same manufacturers, but I dont see anything stamped on sliding door frame like the windows. But the tracks the the sliding doors roll on are worn down wavy making the ... (cont.)

Can you help me identify which replacement part I need for my vista wall commercial door. I hope these pictures help. I wasn't sure on the offset.

I need one handle for my Pulaski Keepsake dresser drawer. Can you help?

Series: Twinseal Double Hung AAMA/NWDA 101/I.S. 2-97 H-R15-46x77 MFR Code:MW-1

Track is worn and needs replaced

Hi, The window channel holders needs to be replaced for the windows. Please help in choosing the correct replacement parts. thanks Mahantesh